**********1986 Nissan 300zx Turbo Coupe 2-door 3.0l********** on 2040-cars

Auto blog

Tier 1 suppliers call GM the worst OEM to work with

Among automakers with a big US presence, General Motors is the worst to work for, according to a new survey from Tier 1 automotive suppliers, conducted by Planning Perspectives, Inc.
The Detroit-based manufacturer, which has been under fire following the ignition switch recall and its accompanying scandal, finished behind six other automakers with big US manufacturing operations. Suppliers had issues with trust and communications, as well as intellectual property protection. GM was also the least likely to allow suppliers to raise their prices in the face of unexpected increases in material cost, all of which contributed to 55 percent of suppliers saying their relationship with GM was "poor to very poor."
GM's cross-town competitors didn't fare much better. Chrysler finished in fifth place, ahead of GM and behind Dearborn-based Ford, which was passed for third place this year by Nissan. Toyota took the top marks, while Honda captured second place.

Nissan recalls Rogue, Pathfinder, Infiniti QX60 for seat issue

Nissan and Infiniti are recalling their 2023 Rogue, Pathfinder and QX60 SUVs and CUVs to address a potential defect in their seat frame welds that can allow the frames to fail in the event of a collision. The number of vehicles that potentially shipped with weak welds is rather small — just over 12,000 — but the issue could nonetheless lead to injury if a failure occurs during a collision.  "The driverÂ’s powered seat may not be fully secured to the seat frame on certain Nissan Rogue, Pathfinder, and INFINTI QX60 vehicles," Nissan's report to NHTSA said. "As a result of this issue, the seat frame welds may detach from the rear inboard seat bracket. If this condition occurs, it may increase the risk of injury to the occupant in the event of a crash. In addition, the seat frame assembly may not meet certain FMVSS 207 and FMVSS 210 requirements because of this condition," Nissan said.  Nissan says there's no easy way for customers to detect the issue ahead of time, and that its seats need to be inspected by a service tech to see whether it is properly secured. Dealers will be instructed to check the driverÂ’s seat rail clearance to the inboard seat bracket, and if necessary, the dealer will remove and replace the affected driverÂ’s seat cushion frame, NIssan said. The entire procedure should take less than two hours.  Owners of affected vehicles should look for notices to be delivered no later than June.  Related video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Recalls Infiniti Nissan Crossover SUV Luxury

Junkyard Gem: 1996 Nissan Quest XE with 338,549 miles

When I hit the junkyard, I always look for vehicles with impressive final figures showing on their odometers. I find so many Hondas and Toyotas with better than 300,000 miles that I don't consider them especially noteworthy (the exception being super-low-spec cheap models, such as a Tercel or Civic VX), and it goes without saying that the bar is quite high for Mercedes-Benzes as well. It has been surprisingly difficult to find discarded Nissans that made it past the 300k mark; today's Junkyard Gem is just the fourth I've documented. The highest-mile junked Nissan I'd found prior to today's minivan is a 1994 Maxima with 364,238 miles, followed by a 1987 Maxima with 341,176 miles and a 1986 200SX with 309,222 miles. Keep in mind that Nissan didn't go to six-digit odometers on most of its US-market cars until the early 1980s, and then went to tough-to-read-in-the-junkyard electronic odometers in the early 2000s; this means the pool of potential high-mile Nissans is limited to about the 1983-2000 range of model years. Ford has just as much right to claim credit to this van's impressive mile total as does Nissan, since the Quest was a collaboration between Ford and Nissan that also produced the Mercury Villager; this van was built by Ford at the Ohio Assembly plant. The Quest/Villager platform was derived from the Maxima's, and the engine is pure Nissan: a 3.0-liter VG30 V6 rated at 151 horsepower. The only transmission available in the first-generation (1993-1999) Quest/Villager was a four-speed automatic. This one appears to have been sold new at Landrum Nissan in Pueblo. The rear glass has been painted flat black, possibly to keep prying eyes from seeing valuable cargo. The rear seats are long gone, so this van probably hauled cargo for much of its long life. The front interior seems to be in good shape. Why is this van here? There's body damage on the left rear and right front, suggesting a crash that may have bent the suspension past the worth-fixing threshold. Perhaps the crinkled metal just made this van too unsightly, or maybe some powertrain problem was the culprit. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. It's time to expect more from a minivan. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. It's all fun and games until the toddler takes the wheel.