1993 Mitsubishi Expo Lrv Base Wagon 2-door 1.8l on 2040-cars

Auto blog

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.

Mitsubishi Motors shareholders approve ouster of Ghosn

TOKYO — Mitsubishi Motors Corp. shareholders approved on Friday the ouster of Carlos Ghosn, who was pivotal in the Japanese automaker's three-way partnership with Nissan and Renault until he was arrested on financial misconduct charges last year. The vote took place in a two-hour general meeting of shareholders at a Tokyo hotel. Nissan Motor Co. owns 34% of Mitsubishi Motors. Osamu Masuko, who was reappointed chairman, promised to strengthen governance and transparency and monitor wrongdoing. More outsiders will check executive appointments and compensation, he said. Nissan shareholders held an extraordinary shareholders' meeting in April to oust Ghosn as chairman. He resigned from French alliance partner Renault SA. The Mitsubishi shareholders also approved the appointment of Renault's chairman Jean-Dominique Senard to replace Ghosn. Renault owns 43% of Nissan. Nissan, based in the port city of Yokohama, is holding a general shareholders' meeting next week to approve other measures, including setting up committees to strengthen governance. Nissan said late Thursday two Renault executives will be on the committees. Renault earlier said it would abstain in that vote, and the greater representation promised on the committees may gain Renault's approval. Renault said in a statement that it welcomed Nissan's decision but did not say how it planned to vote. "The agreement reached on Renault's presence in Nissan's new governance confirms the spirit of dialogue and mutual respect that exists within the alliance," it said. Some analysts suggest a deepening rift between Renault and Nissan after a planned merger between Renault and Fiat Chrysler fell through earlier this month. Nissan expressed reservations about immediately joining the merger. Masuko told shareholders the auto industry faced challenges because of the costs of advancements such as emissions standards and self-driving technology. He said the Tokyo-based automaker will pursue focus over expansion, repeatedly highlighting the company motto "small but beautiful." He also stressed the importance of auto alliances. "We want to be a profitable company even if smaller in scale," he told shareholders. One Mitsubishi Motors shareholder expressed anger over the Ghosn scandal. But most of the questions were about new models and market strategy.

Mitsubishi mulling Mirage sedan for US [w/videos]

Mitsubishi is bringing the Mirage hatchback to the US this fall, carrying a price tag of $12,995, not including the $725 destination charge. Mitsunori Kitao, COO of Mitsubishi Motors Thailand Co., says that the Japanese automaker might consider releasing the sedan version of the Thailand-built compact - called the Attrage in Thailand and the Mirage G4 in the Phillipines - if the little hatchback takes off in the US market, Automotive News reports.
Weight is a key concern with importing the sedan. The non-US Mirage hatchback weighs just 1,900 pounds, but its naturally aspirated 1.2-liter three-cylinder engine makes just 79 horsepower and 78 pound-feet of torque, which can only manage a 0-62 miles-per-hour time of 11.2 seconds. The heavier sedan would take even longer.