2006 Mercury Grand Marquis Gs Sedan 4-door 4.6l on 2040-cars

Auto blog

Junkyard Gem: 1977 Mercury Bobcat

Cultural memory of the Ford Pinto, 38 years after the last new ones were sold, boils down to one thing today: the notorious "exploding Pinto" stories of the late 1970s. Yes, many Pinto jokes were told, the resale value of Pintos crashed, and few paid any attention to the fact that most of the cars sold with the fuel tank between the rear axle and the bumper — that is, just about every Detroit car made during the era — suffered from the same weakness. The Mercury version of the Pinto was badged as the Bobcat, but nobody told Bobcat jokes. Here's a '77 Mercury Bobcat 3-Door in vivid Medium Jade paint, spotted in a Denver self-service yard. The Pinto with glass rear hatch was known as the Pinto Runabout in 1977, while Mercury called this car the " Bobcat 3-door with Glass Third Door." When a car sits for years or decades in High Plains Colorado, rodents tend to nest in it. This Bobcat's air cleaner made a cozy home for our Hantavirus-carrying friends. The 1970s were the last gasp for eye-searingly green vinyl car interiors. Since the Bobcat was a luxed-up Pinto, the door panels have shinier trim than what you'd have had in a proletariat-grade Pinto. Pinto/Bobcat transmission choices boiled down to two: a four-speed manual or a three-speed automatic. Unusually for a Malaise Era Mercury, this one has the manual. Most Pintos and Bobcats came with four-cylinder engines, ranging from the 1.6-liter pushrod Kent to the 2.3-liter engine that lived on for many post-Pinto years in Ford Rangers. This car has the 2.3, rated at 89 horsepower, but the same 2.8-liter Cologne V6 that powered the Capri was available as an option in the Bobcat. That engine made a mighty 93 horsepower. These cars were not too miserable to drive by econobox standards of their time, at least when they had three pedals. You'd blow the doors off a '77 Corolla with a 4-speed Bobcat in a drag race, though the Corolla got better fuel economy. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Gives you hundreds of pounds more car than most small imports and includes standard self-adjusting rear brakes! Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Featured Gallery Junked 1979 Mercury Bobcat View 15 Photos Auto News Mercury Automotive History ford pinto bobcat

NHTSA probing 2000-2003 Ford Taurus and Mercury Sable models over throttle issue

A potential issue with the speed control cable collar has got the 2003-20003 Ford Taurus and Mercury Sable under the spotlight of the National Highway Traffic Safety Administration. If the collar breaks it can cause the throttle to be stuck open.
The issue is limited to vehicles with the 3.0-liter V6 Duratec. There are just 50 complaints so far out of 310,000 cars, but the NHTSA has begun an investigation into whether a recall should be issued.

NHTSA investigating Ford's solution to May 2014 power steering recall

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.