Find or Sell Used Cars, Trucks, and SUVs in USA

1963 Mercury S-22 Comet on 2040-cars

Year:1963 Mileage:0
Location:

Boiling Springs, South Carolina, United States

Boiling Springs, South Carolina, United States
Advertising:

The car has the original bucket seats and console. 14" Magnum wheels with an extra set of tires, a NEW fuel tank, NEW brakes also. All stainless is good. The front pans have been replaced. The engine is a 1972 302 V-8 with a C4 transmission that has been started and ran. There is rust in the left rear quarter and rear pans. The car has a clear title. The car has been in dry storage for the past several years.

Auto Services in South Carolina

Wingard Towing Service ★★★★★

Auto Repair & Service, Towing
Address: Springdale
Phone: (803) 796-1467

Wilkins Motor Company ★★★★★

Used Car Dealers
Address: 242 S Church St, Chesnee
Phone: (828) 245-5086

USA Tire & Auto Care ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Tire Dealers
Address: 1084 Doby`s Bridge Rd, Van-Wyck
Phone: (803) 548-2055

Sumter County Customs ★★★★★

New Car Dealers, Tire Dealers
Address: 2600 Peach Orchard Rd, Shaw-Afb
Phone: (803) 499-1111

Stroman Welding & Auto Repair ★★★★★

Auto Repair & Service
Address: 834 Dills Bluff Rd, Johns-Island
Phone: (843) 637-1673

Spearman Brothers Collision Repair & Refinishing ★★★★★

Automobile Body Repairing & Painting, Automobile Customizing
Address: 2253 S Highway 11, Westminster
Phone: (864) 638-7125

Auto blog

NHTSA investigating 725k Ford, Mercury vehicles for stalling issue

Mon, 25 Feb 2013

Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.

Ford Recalling 70k Escape and Mariner Hybrids for cooling issue

Fri, 12 Sep 2014

Ford is recalling about 70,209 examples of the 2005-2008 Ford Escape Hybrid and the 2006-2008 Mercury Mariner Hybrid because the cooling pumps for their hybrid systems could fail.
According to the company's defect notice, it's possible for the original "Motor Electronics Coolant (MEC) Pump" to wear out and fail, which would could cause the hybrid system to overheat. If this happens, the vehicle goes into a safety mode that takes away most or all of its power. However, braking and steering still operate normally. After cooling down, the affected models restart normally. The company says that it's not aware of any accidents or injuries related to this problem.
Ford will begin repairing the vehicles in late October, and dealers will be installing improved, brushless pumps on the affected models at no charge to owners. If drivers had their pumps fail before this recall, they can contact Ford for a possible reimbursement. Scroll down to read the recall announcement from the National Highway Traffic Safety Administration or download the full defect notice as a PDF, here.

NHTSA investigating Ford's solution to May 2014 power steering recall

Tue, Apr 7 2015

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.