1993 Mercury Capri Base Convertible 2-door 1.6l White on 2040-cars

Auto blog

Junkyard Gem: 1991 Mercury Capri

Ford has gotten a lot of use out of the Capri name in the United States. First, there was the Lincoln Capri in the 1950s, followed by the Ford Capri Mk1 (which was sold by Mercury dealers in the USA but never actually badged as a Mercury). Then came the 1979-1986 Mercury Capri, built on the very successful Fox Platform and essentially a clone of the Mustang. Finally, in 1991, the Australian Ford Capri came to the United States. Here is an example of this rare car that I spotted in a Northern California self-service yard not long ago. Mechanically speaking, the 1991-1994 Capri was a Mazda 323 under the skin, complete with a member of the same B-series engine family that went into such cars as the Miata and Ford Escort. So, for a few years in the early 1990s, car shoppers who wanted a sporty Mazda convertible could choose between a Miata and a Capri. The Capri had front-wheel-drive, but could be had with factory turbocharging. These cars were reliable and fun, but had a tough time competing with the Miata in the showroom battles. You'll see the occasional example now and then, but most of the 1991-1994 Capris have met the same fate that awaits this one. Related Video:

Ford Recalling 70k Escape and Mariner Hybrids for cooling issue

Ford is recalling about 70,209 examples of the 2005-2008 Ford Escape Hybrid and the 2006-2008 Mercury Mariner Hybrid because the cooling pumps for their hybrid systems could fail.
According to the company's defect notice, it's possible for the original "Motor Electronics Coolant (MEC) Pump" to wear out and fail, which would could cause the hybrid system to overheat. If this happens, the vehicle goes into a safety mode that takes away most or all of its power. However, braking and steering still operate normally. After cooling down, the affected models restart normally. The company says that it's not aware of any accidents or injuries related to this problem.
Ford will begin repairing the vehicles in late October, and dealers will be installing improved, brushless pumps on the affected models at no charge to owners. If drivers had their pumps fail before this recall, they can contact Ford for a possible reimbursement. Scroll down to read the recall announcement from the National Highway Traffic Safety Administration or download the full defect notice as a PDF, here.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.