Mx-5 Miata - 2,969 Miles!! *like New* Auto, One Owner, Perfect *70+ Pics* on 2040-cars

Auto blog

Feds investigating Mazda CX-9 over suspension problems

The National Highway Traffic Safety Administration is opening a preliminary evaluation into the 2007-2008 Mazda CX-9 because the lower ball joint in the front suspension can potentially separate while driving. An estimated 54,000 examples of the crossover might be affected. The investigation was prompted by six complaints of this happening on the road. Because the complaints are coming more rapidly as of late, NHTSA thinks the issue could be getting worse. The problem also appears to be more prevalent in states that use salt on their roads in the winter. None of the failures caused any injuries, and all but one happened at 20 miles per hour or slower. NHTSA's preliminary evaluations "assess the scope, frequency, and safety consequence" of a potential problem and can sometimes lead to recalls. Related Video: INVESTIGATION Subject : Front Suspension Ball Joint Separation Date Investigation Opened: JUN 09, 2015 Date Investigation Closed: Open NHTSA Action Number: PE15022 Component(s): SUSPENSION All Products Associated with this Investigation close Vehicle Make Model Model Year(s) MAZDA CX-9 2007-2008 Details Manufacturer: Mazda Motor Corp. SUMMARY: The Office of Defects Investigation (ODI) has received six (6) complaints (VOQs) alleging incidents of front suspension LBJ separation in MY 2007 through 2008 Mazda CX-9 vehicles. The reports appear to show an increasing trend. One of the separations allegedly occurred at 40 mph and the other 5 incidents occurred at speeds between 0 and 20 mph. The first VOQ was received in October 2013, followed by 2 reports in late 2014 and 3 reports in the first 5 months of 2015. Four of the VOQs are from states using high volumes of road salts (?salt states?) which, for purposes of this investigation, include: Connecticut, District of Columbia, Delaware, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia, and Wisconsin. The other VOQs were from northern Virginia, which borders the ?salt state? region, and South Carolina. ODI also identified EWR field report data related to the alleged defect in the subject vehicles. A preliminary investigation is being opened to assess the scope, frequency, and safety consequence of the alleged defect. The six VOQs associated with this investigation are: 10717510, 10714469, 10695142, 10668978, 10640541, and 10546535.

Confirmed: Mazda Miata gets more power, higher redline, telescoping wheel

Our friend over at Road & Track, Bozi Tatarevic, has a keen nose for stuff just like today's Miata news, and he spotted an article by the Japanese car magazine Car Watch that details Mazda's upcoming updates. Car Watch actually got to drive the car, too. There's a lot to go through, but the highlight has to be confirmation of what we told you earlier this year about a significant power bump: The Miata will indeed get an increase of 26 horsepower, from 155 to 181. But the power's not the whole story. Mazda has increased the redline from 6,800 RPM to 7,500. It's not clear at this point where torque and power peaks are in the rev range, or how these changes affect low-speed drivability, but more revs are almost always a good thing and aren't likely to detract from the roadster's fundamental goodness. Car Watch reports that lighter pistons and connecting rods are fitted to help reduce rotational mass in the 2.0-liter inline-four. Some valvetrain changes were needed to support the higher redline, mainly stiffer valvesprings to prevent valve float. Mazda also changed the shape of the valves and optimized the intake ports to breathe better at higher RPM. The inner diameter of the exhaust ports were increased to flow better through a new muffler better tuned to the engine's new operating range. This confirms and gives a little more detail to what we reported earlier based on a leaked document from Mazda Canada. Car Watch also confirms that the revised Miata will get a low-inertia dual-mass flywheel, which should help absorb some vibration, noise and harshness from the higher-revving engine without losing too much of the directness that a single-mass flywheel provides. Mazda usually gets stuff like this right, so while we won't know until we get a chance to drive it whether the DMF feels "right," we're not too worried about it. There's also a telescopic steering wheel, a first in any Miata, which has a range of about 1.1 inches. That doesn't sound like much, but it should help folks with longer legs reach the wheel without having to crank the seat forward. Interestingly, Car Watch reports that the telescoping wheel was opposed by some in the company seeking to save every fraction of an ounce of weight, and to get it through, the company apparently had to change some of the material in the upper steering column from steel to aluminum to satisfy the weight-conscious. Little details like these are fantastic.

2017 North American Car, Truck, and Utility Vehicle of the Year finalists revealed

The finalists for the 2017 North American Car, Truck, and Utility Vehicle of the Year were announced Tuesday at AutoMobility LA ahead of the 2016 LA Auto Show. Approximately 60 judges, including Autoblog's editor-in-chief Mike Austin, evaluated over 40 vehicles and named three models as the finalists in each category. The award for the Utility Vehicle of the Year is new for 2017 and separates SUVs, crossovers, and minivans from pickup trucks. The finalists are: Car of the Year: Chevrolet Bolt Genesis G90 Volvo S90 Truck of the Year: Ford F-Series Super Duty Honda Ridgeline Nissan Titan Utility Vehicle of the Year Chrysler Pacifica Jaguar F-Pace Mazda CX-9 The winners for the 24th annual NACTOY awards will be named on January 9 at the Detroit Auto Show. Related Video: Chevrolet Chrysler Ford Honda Jaguar Mazda Nissan Truck Crossover Minivan/Van SUV Electric Luxury Sedan north american car of the year NACTOY