Custom Mods, Very Clean Mazda Miata 2000 Model on 2040-cars

Auto blog

Mazda recalling 190,000 CX-7s due to rusty ball joints

UPDATE: This post has been updated with additional information from Mazda. The Basics: Mazda is recalling 190,102 Mazda CX-7 crossovers built between February 14, 2006, to May 9, 2012 – model years 2007 through 2012. The Problem: Water can sneak in between the suspension ball joint fittings. If snow and road salt are common in your neck of the woods, the joints can corrode and separate from the lower control arms. That's bad if you enjoy steering your CX-7. According to Mazda, owners of affected models may notice a rattle from the front suspension due to the loose ball joint in the lower control arm fitting. Mazda describes separation of the ball joint and control arm as a "worst case" scenario "after extended operation in such condition." Injuries/Deaths: It's unknown if the rusting issue has led to any crashes, injuries, or deaths. Autoblog has a call into Mazda for additional details and will update this post with any new information. There have been no reports of accidents, injuries, or fatalities related to this recall. The Fix: Owners should report to their local Mazda service center, where techs will replace the both front lower control arms. Any work done is free of charge. If you own one: Mazda will perform some automotive triage with this recall, focusing on CX-7s that have had the longest exposure to salt and are most likely to suffer control arm separation first. Owners of 2007s and 2008s come first, followed by 2009 through 2011 models. Mazda will also focus on vehicles registered in states where snow and road salt are most common – Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, Wisconsin, and Washington, D.C. If you live in a more temperate region or own a 2012 CX-7, Mazda will perform recall work as "parts are available." Owners can contact Mazda customer service at 1-800-222-5500 for additional info. Recall notices should hit the mail around October 10th. Related Video: Featured Gallery 2011 Mazda CX-7: Review View 21 Photos News Source: NHTSAImage Credit: Copyright 2016 AOL Recalls Mazda Crossover mazda cx-7

Feds investigating 2010-11 Mazda CX-9 CUVs over braking issues

The National Highway Traffic Safety Administration is investigating 62,000, 2010-2011 Mazda CX-9 models over brake problems. The government safety watchdog says it has received seven complaints of an observed loss of power braking power to stop the crossover, according to the The Detroit News.
The NHTSA complaints say that the problem causes a hard pedal, increased braking effort and reduced braking effectiveness. Some complaints allege that they hear a hissing noise during braking similar to the sound of air leaving the tires. No injuries or crashes have been reported.
"As always, we are fully cooperating with NHTSA on their investigation. We cannot comment further at this time," said Mazda spokesperson Tamara Mlynarczyk to The Detroit News.

2017 Mazda CX-9 Prototype First Drive

If you read our coverage from last week's Los Angeles Auto Show, you'll note that we were extremely fond of the new Mazda CX-9. We like the look of the thing, inside and out, and it promises to be the best-driving entry in the three-row crossover class. We agree wholeheartedly with that claim. You see, we already drove it. Full disclosure: Our test of the camouflaged CX-9 prototype you see here was short, and while we were able to get a good handle on the CX-9's basic driving dynamics, it'll take more than a 30-mile session around the outskirts of LA to uncover the finer details. What's more, these vehicles are not production ready. In fact, according to our handlers at Mazda, the CUV we tested was actually at the stage before pre-production – so basically, a pre-pre-production car. That said, all the details about the engine, transmission, suspension, and steering are "largely final." As you can see in the gallery, the cars we tested were heavily camouflaged both inside and out. As for styling, we love it – see the undisguised pictures from the LA show for more views. And as for inside, we can say leather seats of our Grand Touring model were comfortable and supportive, and the smallish steering wheel felt natural in the hand. Even in pre-pre-production state, the CX-9 was impressively quiet. An extra 53 pounds of under-floor sound deadening, thicker windows, and active noise cancellation all contribute to what Mazda claims will be "among the quietest vehicles in its class." It's worth noting that the good sounds, like the throaty, whooshy noises of the turbocharged engine, found their way into the cabin just fine. The 2.5-liter, turbocharged four-cylinder engine – Mazda's first force-induced Skyactiv engine – is an excellent piece. The 2.5-liter, turbocharged four-cylinder engine – Mazda's first force-induced Skyactiv engine – is an excellent piece. It uses a variable geometry turbocharger, which the company calls a Dynamic Pressure Turbo. Here's how Mazda explains it: Imagine a normal garden hose. Put your thumb over the nozzle, and the force of the water increases dramatically. That's the DPT at low rpms. It features three small exhaust ports to direct exhaust gases into the turbo, making for 17.4 quick-spooling PSI at low rpms. As the revs climb, a flow control valve opens up, redirecting the gases to a trio of larger ports – removing your thumb from the hose, if you will – and keeping the boost up.