1 Owner Only 38k Low Miles Flatbed New Tires Clean 4cyl Manual Lqqk on 2040-cars

Auto blog

Mazda considering a 'hyper' Mazda3 with the 250-hp 2.5-liter turbo four

Mazda boss Akira Marumoto said last year there'd be no Mazdaspeed version of the new Mazda3 because the hot hatch segment wasn't a priority for the carmaker. Then Mazda engineer Dave Coleman told Road & Track that without "an engine on the shelf that would fit properly," an MPS variant made no sense. The first reader comment on our Coleman post read, "Engine — you have it; cue up the 2.5T." Mazda might have been listening. Program manager Kota Beppu told Autocar he'd like a "hyper" Mazda3, the outlet figuring the 2.5-liter four-cylinder turbo would make the most sense for power. Autocar wrote "the project had not been officially signed off, [but] insiders suggest that is a formality." When Car and Driver queried Mazda and its sources about the report, the magazine realized "the company is seriously considering a high-performance hot hatch." What's more, "Drew Cary, senior manager for brand communications, said, 'We encourage people to ask for it, though. Our planners and executives are watching and listening to fans.'" The turbocharged 2.5-liter SkyActiv-G four-cylinder — which doesn't sell in Europe — makes 250 hp on premium gasoline and 310 pound-feet of torque in the Mazda6, CX-5 and CX-9. A next-generation SkyActiv-G is predicted on the way next year, bringing more boost and power. Even as is, we're talking a chunky lump of power to send to the front wheels, and Beppu mentioned torque steer. The new Mazda3's all-wheel drive would alleviate that bugbear. Unlike the raw, fast-twitch reflexes of the last Mazdaspeed3 from 2013, Beppu says a new model "needs to be responsible and friendly ... more friendly than a Golf GTI." And, "It should be fast." The polished looks and interior address the necessary perceptions. CD's done the math on the current 2.5-liter and predicts a five-second sprint to 60 miles per hour, which is Volkswagen Golf R and Honda Civic Type R territory, so GTI comparisons could be a case of aiming low. Imagine a 300-hp engine with a touch more torque and a six-speed manual ... If Mazda follows through with such a product, it could take two years to get the green light. However, we're told that Mazda's Los Angeles research and development center has already built a proof-of-concept to encourage and anticipate that green light.

Confirmed: Mazda Miata gets more power, higher redline, telescoping wheel

Our friend over at Road & Track, Bozi Tatarevic, has a keen nose for stuff just like today's Miata news, and he spotted an article by the Japanese car magazine Car Watch that details Mazda's upcoming updates. Car Watch actually got to drive the car, too. There's a lot to go through, but the highlight has to be confirmation of what we told you earlier this year about a significant power bump: The Miata will indeed get an increase of 26 horsepower, from 155 to 181. But the power's not the whole story. Mazda has increased the redline from 6,800 RPM to 7,500. It's not clear at this point where torque and power peaks are in the rev range, or how these changes affect low-speed drivability, but more revs are almost always a good thing and aren't likely to detract from the roadster's fundamental goodness. Car Watch reports that lighter pistons and connecting rods are fitted to help reduce rotational mass in the 2.0-liter inline-four. Some valvetrain changes were needed to support the higher redline, mainly stiffer valvesprings to prevent valve float. Mazda also changed the shape of the valves and optimized the intake ports to breathe better at higher RPM. The inner diameter of the exhaust ports were increased to flow better through a new muffler better tuned to the engine's new operating range. This confirms and gives a little more detail to what we reported earlier based on a leaked document from Mazda Canada. Car Watch also confirms that the revised Miata will get a low-inertia dual-mass flywheel, which should help absorb some vibration, noise and harshness from the higher-revving engine without losing too much of the directness that a single-mass flywheel provides. Mazda usually gets stuff like this right, so while we won't know until we get a chance to drive it whether the DMF feels "right," we're not too worried about it. There's also a telescopic steering wheel, a first in any Miata, which has a range of about 1.1 inches. That doesn't sound like much, but it should help folks with longer legs reach the wheel without having to crank the seat forward. Interestingly, Car Watch reports that the telescoping wheel was opposed by some in the company seeking to save every fraction of an ounce of weight, and to get it through, the company apparently had to change some of the material in the upper steering column from steel to aluminum to satisfy the weight-conscious. Little details like these are fantastic.

2016 Mazda MX-5 Miata design walkaround

By now, you've likely read what we think of the 2016 Mazda MX-5 Miata's new looks both inside and out, and you've probably poured over the available photos and started to make up your own mind about the roadster's radically more aggressive new appearance. More than likely, however, you haven't heard much from Mazda itself about its new design, and we're here to remedy that. Join Autoblog as we go over the new Miata from tip to tail with Derek Jenkins, Mazda North America's director of design. Jenkins, a veteran of both Audi and Volkswagen design studios, has been with the Japanese automaker for nearly four years, and he's kept a close eye in the ND Miata program along with his team in Irvine, CA. Check out our video to see Jenkins explain his team's exterior and cabin handiwork and to learn a little more about why the new model graduates from the Miata's historically cute and friendly aesthetic to something altogether more assertive.