Automatic All Power Factory Warranty No Dealer Fees Off Lease Only on 2040-cars

Auto blog

Mazda2 sedan debuting in Thailand this month?

Mazda is reportedly set to introduce a Mazda2 with a four-door sedan body. Unlike the upcoming CX-3, which is debuting at the upcoming Los Angeles Auto Show and is almost certain to be sold in North America, this other version's chance here are a bit more mysterious.
According to The Bangkok Post, the Mazda2 sedan will make its word debut at the Thailand International Motor Expo on November 28, and the traditional five-door hatch will be there as well. Both body styles will be built in Thailand with diesel engines and will be the first vehicles to adhere to the country's eco-car rules for oil-burners with a SkyActiv 1.5-liter diesel that will make 105 horsepower.
At this time, there's no indication whether the new sedan might also be sold in the US, but we're not holding our breath - remember, the previous Mazda2 sedan never made it Stateside, either.

2019 Mazda CX-5 Turbo First Drive Review | Two-row crossover perfection

Listen: If you're shopping for a crossover, and by all accounts most Americans are, there is no better option on the market than the 2019 Mazda CX-5. When we test drove the all-new 2017 CX-5, we were astounded by its marked improvements over the already-great previous generation. We noted then its biggest drawback was its average 187 horsepower. The CX-5 didn't feel slow, and it certainly made up for it in other ways, like by delivering superior road-hugging abilities. But, it was probably enough to turn off buyers who do their shopping by analyzing spec sheets. For 2019, Mazda addressed that exact issue with a vengeance. With an all-new 2.5-liter SkyActiv Turbo good for 250 horsepower, the CX-5 not only leapfrogs bestselling rivals like the Honda CR-V and Toyota RAV4, but lands squarely in the realm of luxury stalwarts such as the Audi Q5 and BMW X3. When we drove the 2017 CX-5, we likened the handling to that of a Porsche Macan. Now it has the power to match. Among its direct competition, only the 2019 Toyota RAV4 breaks the 200-horsepower mark, ringing in at 203 (and the Hybrid makes an even more impressive 219 ponies), while the Honda CR-V, Subaru Forester and VW Tiguan all sit between 180 and 190. Now, to get the full herd you must fill the tank with 93 octane premium, but if you don't mind leaving a few ponies in the stable you can pump 87 octane for a slight dip to 227 horsepower. The engine adjusts with no ill effects. Even better, torque stays the same no matter what, and the stump-pulling 310 pound-feet of torque comes quick at just 2,000 rpm. The SkyActiv turbo is full of clever engineering tricks, too. There's an exhaust port restrictor, for instance, a narrower channel used only at low engine speeds. Mazda engineer Dave Coleman likened it to a thumb over a firehose, making more exhaust pressure at idle to spool up the turbo, and thus delivering more oomph when you take off from a standstill. Mazdafarians will recognize the mill as the same one that debuted on the 2018 Mazda6. It powers the CX-9 too, Mazda's highly acclaimed three-row crossover. The 3,825-pound CX-5 has 558 fewer pounds to shuffle around than its larger stablemate, making it downright snappy. However, that extra pep does come with a fuel economy penalty, 22 city and 27 highway mpg versus the naturally aspirated version's 24 city and 30 highway mpg.

Mazda recalling 190,000 CX-7s due to rusty ball joints

UPDATE: This post has been updated with additional information from Mazda. The Basics: Mazda is recalling 190,102 Mazda CX-7 crossovers built between February 14, 2006, to May 9, 2012 – model years 2007 through 2012. The Problem: Water can sneak in between the suspension ball joint fittings. If snow and road salt are common in your neck of the woods, the joints can corrode and separate from the lower control arms. That's bad if you enjoy steering your CX-7. According to Mazda, owners of affected models may notice a rattle from the front suspension due to the loose ball joint in the lower control arm fitting. Mazda describes separation of the ball joint and control arm as a "worst case" scenario "after extended operation in such condition." Injuries/Deaths: It's unknown if the rusting issue has led to any crashes, injuries, or deaths. Autoblog has a call into Mazda for additional details and will update this post with any new information. There have been no reports of accidents, injuries, or fatalities related to this recall. The Fix: Owners should report to their local Mazda service center, where techs will replace the both front lower control arms. Any work done is free of charge. If you own one: Mazda will perform some automotive triage with this recall, focusing on CX-7s that have had the longest exposure to salt and are most likely to suffer control arm separation first. Owners of 2007s and 2008s come first, followed by 2009 through 2011 models. Mazda will also focus on vehicles registered in states where snow and road salt are most common – Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, Wisconsin, and Washington, D.C. If you live in a more temperate region or own a 2012 CX-7, Mazda will perform recall work as "parts are available." Owners can contact Mazda customer service at 1-800-222-5500 for additional info. Recall notices should hit the mail around October 10th. Related Video: Featured Gallery 2011 Mazda CX-7: Review View 21 Photos News Source: NHTSAImage Credit: Copyright 2016 AOL Recalls Mazda Crossover mazda cx-7