2005 Mazda 3 Sp23 Hatchback 4-door 2.3l on 2040-cars

Auto blog

Japanese automakers welcome North American trade deal, fear what's next

TOKYO — Toyota, Nissan and Mazda welcomed on Tuesday the revised North America trade deal that left Japanese automakers unscathed, but they may face a bumpy ride when Washington and Tokyo hold new talks on over $40 billion of annual U.S. auto imports from Japan. The United States and Canada reached an agreement on Sunday to update the 1994 North American Free Trade Agreement after Washington had forged a separate trade deal with Mexico in August. The updated deal effectively maintains the auto industry's current footprint in North America, and spares Canada and Mexico from the prospect of U.S. national security tariffs on their vehicles. Mazda, which ships cars to the United States from Mexico and Japan, called the deal a "big step forward". Nissan, which makes the cars it sells in the United States locally as well as in Mexico, Japan and other countries, said it was "encouraged" by the agreement. Toyota, Japan's biggest automaker, said it was "pleased" that a basic deal was reached. Other automakers were not immediately available for comment. While the deal has removed the risk that the disintegration of the pact would have posed to automakers, bigger risks loom large for Japanese firms as a chunk of the roughly 7 million cars they sold in the U.S. last year were shipped from Japan, and a trade deal between Washington and Tokyo has yet to be agreed. The United States and Japan last week agreed to begin fresh trade talks, with U.S. President Donald Trump seeking to address Japan's $69 billion trade surplus, of which nearly two-thirds comes from auto exports. Washington is also investigating the possibility of slapping 25 percent tariffs on auto imports on national security grounds, although it has agreed with Japan to put any new tariffs on hold during the talks. Analysts say the United States may take a tougher stance on auto imports from Japan than from its neighbors. "If Japan requests an exemption from the 25 percent tariffs under consideration, Washington could propose a more strict cap on imports than it agreed to with Mexico and Canada," said Koji Endo, senior analyst at SBI Securities. "That would be a risk." This could be a big blow to Japan, as the United States is a key source of revenue for Japanese automakers including Toyota, Nissan and Honda. The U.S. market accounts for a quarter or more of their annual global vehicle sales, and of their total U.S.

Confirmed: Mazda Miata gets more power, higher redline, telescoping wheel

Our friend over at Road & Track, Bozi Tatarevic, has a keen nose for stuff just like today's Miata news, and he spotted an article by the Japanese car magazine Car Watch that details Mazda's upcoming updates. Car Watch actually got to drive the car, too. There's a lot to go through, but the highlight has to be confirmation of what we told you earlier this year about a significant power bump: The Miata will indeed get an increase of 26 horsepower, from 155 to 181. But the power's not the whole story. Mazda has increased the redline from 6,800 RPM to 7,500. It's not clear at this point where torque and power peaks are in the rev range, or how these changes affect low-speed drivability, but more revs are almost always a good thing and aren't likely to detract from the roadster's fundamental goodness. Car Watch reports that lighter pistons and connecting rods are fitted to help reduce rotational mass in the 2.0-liter inline-four. Some valvetrain changes were needed to support the higher redline, mainly stiffer valvesprings to prevent valve float. Mazda also changed the shape of the valves and optimized the intake ports to breathe better at higher RPM. The inner diameter of the exhaust ports were increased to flow better through a new muffler better tuned to the engine's new operating range. This confirms and gives a little more detail to what we reported earlier based on a leaked document from Mazda Canada. Car Watch also confirms that the revised Miata will get a low-inertia dual-mass flywheel, which should help absorb some vibration, noise and harshness from the higher-revving engine without losing too much of the directness that a single-mass flywheel provides. Mazda usually gets stuff like this right, so while we won't know until we get a chance to drive it whether the DMF feels "right," we're not too worried about it. There's also a telescopic steering wheel, a first in any Miata, which has a range of about 1.1 inches. That doesn't sound like much, but it should help folks with longer legs reach the wheel without having to crank the seat forward. Interestingly, Car Watch reports that the telescoping wheel was opposed by some in the company seeking to save every fraction of an ounce of weight, and to get it through, the company apparently had to change some of the material in the upper steering column from steel to aluminum to satisfy the weight-conscious. Little details like these are fantastic.

Mazda will sell a removable MX-5 Miata hardtop only to racers

Before the advent of the power-folding hardtop NC or the newer MX-5 RF targa, you could buy a fiberglass hardtop to plop on your soft-top Miata. Expensive when new and rather rare, they command top dollar now. And moreover, Spec Miata racers have always sought them for use in that series. Now, what's old is new again, sort of. Mazda Motorsports will sell a removable hardtop for $4,420, but there's a catch. You have to purchase a MX-5 Cup Global race car to order one. A Mazda spokesperson confirmed to Autoblog that non-Cup racers won't be able to purchase a new hardtop for their ND – and furthermore, since it's oddly shaped to clear the rollcage, they might not want to. Second-hand, who knows? Even though it's pricey, it'd offer a different experience than you get from the sexy RF. Related Video: Motorsports Mazda Convertible Racing Vehicles Performance mazda mx-5