2010 Mazda Cx-9 Grand Touring Sport Utility 4-door 3.7l on 2040-cars

Auto blog

2016 Mazda2 gets EPA-rated 43 mpg highway

To paraphrase the famous quote from astronaut Neil Armstrong, that's one small step for man and one giant leap for the Mazda2. The Environmental Protection Agency (EPA) has weighed in on the new Mazda2 version, and says it gets a fuel-economy rating of 33 miles per gallon city and 43 mpg highway with a six-speed automatic transmission. Stick-shift gas-mileage figures are 31 city and 42 highway, which are still substantially better than the 29/35 rating from the most recent iteration of the model. That's about a 15-percent jump in fuel economy, people. More importantly, the Mazda2 beats out competitors such as the Hyundai Accent, Kia Rio Eco and even the Honda Fit in terms of fuel efficiency, which is pretty good company. The Mazda2 boasts a 1.5-liter four-cylinder engine. But it is the upgrade to six-speed transmissions in both manual and automatic versions that seem to be making the biggest difference in the ratings. Mazda started unveiling details about the next-generation Mazda2 last year, and last fall began production of the model at Mazda's new factory in Salamanca, Mexico. At that time, the Japanese automaker had already sold more than 2.4 million Mazda2 vehicles since the model's introduction in 1996. Related Video:

Mazda, Suzuki, Yamaha — more vehicle data fabrication found in Japan

TOKYO — Mazda, Suzuki and Yamaha improperly tested vehicles for fuel economy and emissions, the Japanese government said on Thursday, revealing fresh cases of compliance failures by manufacturers. The results came to light after the Japanese government had ordered the automakers to check their operations after revelations of improper testing at Subaru and Nissan last year. The conduct of automakers globally has come under intense scrutiny after Germany's Volkswagen AG admitted in 2015 to installing secret software in hundreds of thousands of U.S. diesel cars to cheat exhaust emissions tests, and that as many as 11 million vehicles could have similar software installed worldwide. In the Japanese cases, the carmakers have not broken any laws or prompted massive recalls. But a growing list of improprieties has tarnished the image of the country's manufacturing industry for high-quality products and efficiency. Suzuki, Mazda and Yamaha cleared vehicles for emissions or fuel efficiency even in cases where they were tested under invalid conditions, the ministry said in a statement. The errors related to slight deviations in the speed of the vehicles during testing that should have invalidated the test results. The automakers examined tests they had conducted over different periods of time, and in Suzuki's case they stretched back to 2012. None of the automakers found significant problems with actual emissions and fuel economy performance of the vehicles, which were destined for sale in Japan, and do not plan any recalls. Suzuki, Japan's fourth-largest automaker, said that of 12,819 sample vehicles tested for fuel economy and emissions since June 2012, around 50 percent of them had been inspected improperly. "I deeply apologize and will lead efforts to prevent recurrence," Suzuki Chief Executive Toshihiro Suzuki told a news conference. Mazda said there were irregularities in 4 percent of similar inspections on its cars, or just over 70 vehicles. In Yamaha's case, irregularities were found in 2 percent of inspections, or just a handful of vehicles. Both Mazda and Yamaha apologized. Suzuki and Yamaha shares fell 6 and 5 percent, respectively, and Mazda shares were down 1 percent, underperforming a steady benchmark Nikkei average. In July this year, Nissan admitted it had improperly measured exhaust emissions and fuel economy for 19 vehicle models sold in Japan.

Mazda recalls 193k CX-9 crossovers over corroded suspension

An issue with the suspension on the CX-9 has prompted Mazda and the National Highway Traffic Safety Administration to recall 193,484 vehicles across the United States. The campaign specifically affects units from the 2007-2014 model years, manufactured between October 24, 2006, and December 28, 2013. In those affected vehicles, the ball joints in the front suspension may corrode due to water leaking into the fitting. According to the statement below, if the ball joint rusts, the front lower control arm could separate, resulting in a loss of steering control. And needless to say, that could lead to a crash. To repair the issue, Mazda will have to replace both the left and right lower control arms, and will naturally do so free of charge, but will undertake the repairs in stages. First, owners of the affected vehicles will receive a notification that a recall campaign is under way. Then they'll get a second letter when the parts are ready and they can bring their vehicles into their local dealers. The company will start first with 2007-09 vehicles, specifically those registered in the snowy states of the Northeast and Midwest. Specifically: Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, Wisconsin, and Washington, DC. (Oddly, states in the the western portion of the Midwest, as well as the Rocky Mountains and the Pacific Northwest, were not included in that initial phase. Nor was Alaska, for that matter.) After that they'll call in 2010-14 models in the same states before undertaking repairs on vehicles in other areas to the west and south. Related Video: RECALL Subject : Corrosion of Front Suspension Ball Joint Report Receipt Date: JUL 20, 2015 NHTSA Campaign Number: 15V451000 Component(s): SUSPENSION Potential Number of Units Affected: 193,484 Manufacturer: Mazda North American Operations SUMMARY: Mazda North American Operations (Mazda) is recalling certain model year 2007-2014 CX-9 vehicles manufactured October 24, 2006, to December 28, 2013. The affected vehicles have front suspension ball joints that may corrode from water leaking into the fitting. CONSEQUENCE: Over time, the ball joint corrosion may result in the front lower control arm separating from the ball joint, causing a loss of steering control and increasing the risk of a crash.