2007 Mazda Cx-9 Grand Touring Awd Sunroof Nav 20's 29k Texas Direct Auto on 2040-cars

Auto blog

2019 Mazda 3 recalled because the wheels could fall off while driving

Here’s a recall we had to read twice before believing. Mazda is bringing in 25,003 Mazda 3s that just rolled off the assembly line, because the wheels may fall off while driving. All the Mazda 3s are 2019 model year cars, so itÂ’s only the totally new generation Mazda 3 under the gun here. Thankfully, Mazda says there are no cases of this occurring to owners, and therefore no injuries or deaths related to the issue. As for the cause of the wheel detachment? Mazda put out a statement explaining the issue at hand.  “A manufacturing process error may result in a gap between the wheel hub bolt and hub flange during assembly. This gap causes loosening of the lug nuts though they were initially tightened to the correct specification at the plant. A rattling noise occurs prior to a wheel detachment from the vehicle,” Mazda says. ItÂ’s heartening to see Mazda did in fact tighten the lugs at the factory, but still extremely troubling to see that they can loosen all on their own. Our advice? Walk on out to your shiny, new Mazda 3 and torque those lugs to spec. If you donÂ’t have a torque wrench, then just use the wrench that came with the car to make sure theyÂ’re not loose. Those that have a new Mazda 3 should be on the lookout for a recall notice in the mail. YouÂ’ll then be able to take the car to the dealer for Mazda to fix the problem. Until then, just keep an eye on your lugs. A wheel flying off while driving at speed is always a recipe for disaster, and we sure do enjoy driving the new Mazda 3 at speed.

NFL player Alfred Morris receives his thoroughly restored 1991 Mazda 626

Washington Redskins starting running back Alfred Morris might not drive a flashy sports car or SUV, but after today, he'll be driving the nicest 1991 Mazda 626 on the planet.
Back in July, Morris temporarily traded in his 626 - cheekily named Bentley - for a 2014 Mazda6 loaner courtesy of Mazda, and today the sedan was presented back to him after the ultimate PR stunt: a reported 275-man-hour restoration that left this 22-year-old daily driver looking like it just rolled off the assembly line.
Not everything was brought back to original condition, though. The expired sticker from Morris' final year at Florida Atlantic University was left on the windshield, but to fit the car's nickname, a few high-end touches were added to the interior. This includes the quilted, cross-stitched leather seats (just like a real Bentley) and the touchscreen Pioneer audio system. There's also a plaque under the hood marking this car as the "Alfred Morris Project."

Mazda recalling 190,000 CX-7s due to rusty ball joints

UPDATE: This post has been updated with additional information from Mazda. The Basics: Mazda is recalling 190,102 Mazda CX-7 crossovers built between February 14, 2006, to May 9, 2012 – model years 2007 through 2012. The Problem: Water can sneak in between the suspension ball joint fittings. If snow and road salt are common in your neck of the woods, the joints can corrode and separate from the lower control arms. That's bad if you enjoy steering your CX-7. According to Mazda, owners of affected models may notice a rattle from the front suspension due to the loose ball joint in the lower control arm fitting. Mazda describes separation of the ball joint and control arm as a "worst case" scenario "after extended operation in such condition." Injuries/Deaths: It's unknown if the rusting issue has led to any crashes, injuries, or deaths. Autoblog has a call into Mazda for additional details and will update this post with any new information. There have been no reports of accidents, injuries, or fatalities related to this recall. The Fix: Owners should report to their local Mazda service center, where techs will replace the both front lower control arms. Any work done is free of charge. If you own one: Mazda will perform some automotive triage with this recall, focusing on CX-7s that have had the longest exposure to salt and are most likely to suffer control arm separation first. Owners of 2007s and 2008s come first, followed by 2009 through 2011 models. Mazda will also focus on vehicles registered in states where snow and road salt are most common – Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, Wisconsin, and Washington, D.C. If you live in a more temperate region or own a 2012 CX-7, Mazda will perform recall work as "parts are available." Owners can contact Mazda customer service at 1-800-222-5500 for additional info. Recall notices should hit the mail around October 10th. Related Video: Featured Gallery 2011 Mazda CX-7: Review View 21 Photos News Source: NHTSAImage Credit: Copyright 2016 AOL Recalls Mazda Crossover mazda cx-7