2013 Maserati Gran Turismo Mc,1 Owner,100% Original,clean Carfax,florida Car!!! on 2040-cars

Auto blog

Maserati MC20 spy photos show supercar in broad daylight

The upcoming Maserati MC20 mid-engine supercar has been teased a number of times, but thanks to new spy photos, we finally get a clear look at the prototype. Our spy photographer caught the MC20 in broad daylight from nearly every angle, and it was wearing relatively thin camouflage. The nose of the MC20 seems to take a lot of inspiration from past and present Maseratis. It has a slightly more aggressive oval grille that will house a big trident square in the middle. Two smaller grilles flank the center one. The headlights and hood design look slightly reminiscent of the MC12 supercar, which was based on the Ferrari Enzo. The lights have a similar shape that looks like it might wrap down around the sides of the fender. The little vents in the hood also call to mind the MC12. The sides of the MC20 aren't too over-the-top. It has two relatively small intakes in the rear fender, one upper and one lower. There's a small vent in the front fender. The body's lines are smooth and curvy. The rear pillar is fairly thick and the side skirts are rather deep. The wheels have quite a bit of vinyl covering, but they seem to have some sort of three-spoke or split three-spoke design. At the rear of the car, there are few wings, spoilers or other aerodynamic paraphernalia besides the simple rear lip to distract from the clean curves. What we can see of the taillights suggests thin, wide units with arrow-like points in the lighting elements. There appear to be plenty of vents for cooling and aerodynamics, and the twin tailpipes exit roughly in the middle and a bit inset to the edges of the car. While we don't know all the details about the car, we know a fair bit about what will power it. It will use a twin-turbo 3.0-liter V6 making 630 horsepower and 538 pound-feet of torque. It's also an in-house engine, not one built by Ferrari. There have been reports that the engine could see a hybrid version with multiple electric motors appear with over 700 horsepower, but it's also possible that those reports of an electrified engine could simply be referring to a 48-volt mild-hybrid assist that could be a part of the standard V6. We're expecting the regular V6 MC20 will be rear-wheel-drive with some kind of dual-clutch or conventional automatic transmission. If the high-output hybrid rumors are true, that version would likely be all-wheel-drive. We should know more when the car makes its debut this September. Related Video:    

2019 Maserati Ghibli GranLusso S Quick Spin Review | A mixed designer bag

It's been a minute since we've driven the Maserati Ghibli (our first drive was way back in 2013), the twin-turbocharged, V6-powered smaller sedan from the legendary Italian outfit. In the last couple years, rumors have swirled that the Ghibli would donate its platform to the Dodge Charger and its Challenger and 300 siblings. So, in a sense, our time in Southern California in the 2019 Maserati Ghibli GranLusso S was both a preview of FCA's shared rear-drive sedan future as well as a check-in about how the Ghibli is maturing in general. Not that the Ghibli hasn't evolved in the six years since it went on sale. For 2018, Maserati moved to an electrically-assisted steering rack, mostly to enable driver assistance systems with steering intervention. The V6's output has been bumped in the S, to 424 horsepower. The headlights and grille have been updated, too, to compliment the newer and more aggressive Levante. In Los Angeles, at least, the Ghibli doesn't stand out – the town is lousy with Ghiblis, Levantes, and Quattroportes. Good for Maserati, I suppose, but bad for exclusivity. Nor does the car pop in photos like it does in person. My tester was a metallic, creamy white, which is flat and dull in photos or from far away. That's a shame, because this car has phenomenal contouring. From behind the wheel, the driver's side fender porpoises above the shapely hood. Walking along the side, the curvature of the rear fender where it meets the deep tumblehome of the C-pillar is delightful. Everybody stares at an exotic, but the owner of a Ghibli should feel special contemplating their sheetmetal. This sense of specialness dissolves inside. There are Maserati tridents everywhere, presumably to help you remember that you're looking at the expensive Italian sports sedan you just purchased rather than a riot of low-rent, Chrysler-derived bits. The steering wheel buttons feel cheap and wobbly, the too-shiny center console finish seems synthetic, the prominent lighting and engine start/stop controls to the left of the steering wheel are ensconsed in a dull plastic surround. Some of the aesthetic choices – subjective, yes – are confounding. Take the textile inserts on the seats and door cards. I love the fact that interior designers are playing with textiles, which can be used to great effect. And the pitch here is compelling: an apparently famous Italian designer (Ermenegildo Zegna) used a fancy fabric (mulberry silk) with special weaves and textures.

Stellantis announces ‘Circular Economy’ business to drive revenue, decarbonization

Stellantis has already announced its plans to reach net-zero carbon emissions by 2038. Today, the automaker has announced a new business unit to help it reach that goal while generating 2 billion euros per year in revenue by 2030. The “Circular Economy” business will help make revenue less dependent on finite, rare and ecologically problematic materials. The Circular Economy model features what Stellantis calls a “4R” strategy, comprising remanufacturing, repair, reuse and recycling. The goal is to make materials last as long as they can, reducing reliance on the acquisition of those precious new materials in the future by returning them to the business loop when theyÂ’ve reached the end of their first life. Through these processes, Stellantis says it can save up to 80% raw material and 50% energy compared to manufacturing a new part. Remanufacturing, or “reman” in Stellantis shorthand, means dismantling, cleaning and rebuilding parts to OEM spec. Nearly 12,000 remanufactured parts are available for customers to purchase. Some remanufacturing is done in-house, and some with partners and through joint ventures. Repair is pretty obvious — fixing parts to put back into vehicles. This also consists of reconditioning, to make a vehicle feel like new. Stellantis boasts 21 “e-repair” centers for repairing electric vehicle batteries.  Reuse refers to parts still in good condition from end-of-life vehicles sold as-is. Stellantis says it has 4.5 million multi-brand parts in inventory. These are sold in 155 countries through the B-Parts e-commerce platform. Reuse also refers second-life options, such as using batteries outside of automotive purposes. Recycling involves dismantling parts and scraps back into raw material form that is then looped back into the manufacturing process. Stellantis says it has collected 1 million parts for recycling in the past six months. Recycling doesnÂ’t get counted in that aforementioned 2 billion euros of revenue, but it does save the company money on acquisition of raw materials. As for batteries, specifically, Stellantis expects this recycling business to ramp up after 2030, when the packs currently in service begin to reach the end of their lifecycle. Stellantis will use its new “SUSTAINera” label to denote parts that are offered as part of its Circular Economy business.