2010 Lincoln Mks Ecoboost on 2040-cars

Auto blog

Ford recalls 9,900 vehicles across two campaigns

Ford is recalling a total of 9,885 vehicles in two campaigns. The Basics: In one recall, Ford will recall 9,017 examples of the 2013 Escape with build dates from January 11, 2012, to April 1, 2013, and the 2013-2014 Focus ST produced between May 3, 2012, and October 14, 2013. The Problem: Splices in the engine wiring harness might not have enough compression, and this can cause the manifold absolute pressure sensor to send incorrect signals to the powertrain control module. This issue could cause the engine to stall. Injuries/Deaths: None reported. The Fix: Dealers will replace the current crimped splices with new splices, according to the National Highway Traffic Safety Administration. If You Own One: The repair campaign will begin on January 4, 2016. More Information: Ford recalled the 2013 Escape and Focus ST in August 2014 for the same problem, and this is an expansion of that campaign, according to company spokesperson John Cangany to Autoblog. The Basics: In the smaller of the two campaigns, Ford will recall 868 examples of the 2013 Explorer, Explorer Police Utility, Taurus, Taurus Police Interceptor, Flex, Lincoln MKS, and MKT. The Problem: The fuel delivery module can crack, which would cause a fuel leak. Injuries/Deaths: None reported. The Fix: Dealers will replace the fuel delivery module. If You Own One: Owners should receive notice soon because NHTSA's report says the recall begins in December. More Information: According to Cangany, this recall is an expansion of a campaign from 2013 for these vehicles. RECALL Subject : Engine Wiring Splices may cause Stall Report Receipt Date: DEC 02, 2015 NHTSA Campaign Number: 15V813000 Component(s): ELECTRICAL SYSTEM Potential Number of Units Affected: 9,017 All Products Associated with this Recall Vehicle Make Model Model Year(s) FORD ESCAPE 2013 FORD FOCUS 2013-2014 Details Manufacturer: Ford Motor Company SUMMARY: Ford Motor Company (Ford) is recalling certain model year 2013 Escape vehicles manufactured January 11, 2012, to April 1, 2013, and 2013-2014 Focus ST vehicles manufactured May 03, 2012, to October 14, 2013. Insufficient compression in the engine wiring harness splices to the Manifold Absolute Pressure (MAP) sensor may provide incorrect signals to the powertrain control module (PCM). CONSEQUENCE: The incorrect signals could cause the vehicle to hesitate or the engine to stall, increasing the risk of a crash.

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

Ford's BlueCruise gains hands-free lane changes and more in update

Ford is sending out an update to BlueCruise that will enhance its functionality with some nice features we tend to enjoy on other advanced driver assistance systems. Plus, in addition to BlueCruise getting the update, the Lincoln version named ActiveGlide will get the same update. For starters, both BlueCruise and ActiveGlide will gain hands-free lane changing. Similar to other lane-change assist systems, you’ll prompt the lane change by activating the turn signal. ItÂ’ll scan for traffic, and if all is clear, the vehicle will move into the requested lane. Ford says that itÂ’ll even suggest lane changes to the driver in the cluster as you approach slower-moving traffic. What this new feature doesnÂ’t do, though, are automatic lane changes. Systems like Super Cruise and TeslaÂ’s Autopilot will recognize slower traffic, then make a pass all on their own to move around said traffic — theyÂ’ll even move back over into your previous lane after making the pass. We wouldnÂ’t be surprised if Ford adds this functionality to the system in a future update. Another update in this release is new “In-Lane Repositioning” programming. ItÂ’s designed to recognize when there are vehicles in adjacent lanes and will then shift you further away from them within your lane of travel. Ford says itÂ’s especially helpful when passing semi-trucks, and will give you the usual and more comfortable buffer that a human driver might give a truck. The final update is a Predictive Speed Assist feature that will adjust your speed as you approach a curve. It will signal to the driver in the cluster that the car will slow for a curve, then do so gradually as you approach it. This is the sort of feature we typically like to turn off as soon as possible, since weÂ’d rather just remain at the same speed for curves on the highway. But, if youÂ’re one of those folks who like to slow down for curves on the highway, this will provide a more natural driving feel. Ford says that customers have cumulatively put over 16 million hands-free miles on cars with BlueCruise at this point. This update, simply named 1.2, for BlueCruise and ActiveGlide will see its initial rollout this fall. It will hit the Mustang Mach-E first, and Ford says other vehicles will follow. Related video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. POV drive of the 2021 Ford Mustang Mach-E