2013 Jeep Grand Cherokee 4wd Srt8 7k Low Mile Active Cruise Pano Sr Clean Carfax on 2040-cars

Auto blog

Jeep going bigger with new Grand Wagoneer, smaller with sub-Renegade?

The headlines are still rolling in for the new Renegade that Jeep unveiled at the Geneva Motor Show last week, but already reports are surfacing, citing sources within the company, about what Chrysler's iconic off-road brand will do next.
Speaking with Auto Express (whose reports we tend to take with a grain of salt or two), Jeep chief Mike Manley suggested that two courses of action are currently under consideration at Auburn Hills to develop two very different new models - one smaller and one larger than anything Jeep currently makes.
One plan would be to make an SUV or crossover even smaller than the new Renegade, although it isn't immediately clear what platform it would take. The Renegade (pictured above in Trailhawk spec) will be built in Italy alongside Fiat's upcoming 500X, but uses a heavily modified platform. We figure the smaller model, if approved, could base itself on the new Fiat Panda Cross.

Chrysler recalls 350k vehicles over ignition switches

Chrysler has announced a recall covering 349,442 vehicles due to ignition switches that can either become stuck or move without warning. All of the affected vehicles are from the 2008 model year, and were built before May 12, 2008.
The automaker has learned that ignition keys on some vehicles "may not fully return to the 'ON' position after rotation to the 'START' position during engine-startup," the company said in a statement. Additionally, "an ignition key may not fully return to the 'ON' position after rotation to the 'START' position and may inadvertently move through the 'ON' position to 'ACCESSORY' or 'OFF.'"
Chrysler says it is unaware of any related injuries, and notes that while reduced braking, engine or steering power is possible in such instances, the airbags are not affected. The later stands in contrast to General Motors' recent rash of high-profile recalls, and it's an important distinction that Chrysler (understandably) felt necessary to call out in bold print in its press release.

Jeep owner inadvertently receives 2018 Wrangler hood from scrapyard

After an apparent mix-up, FCA may be looking for a new scrapyard to which to send prototype parts. JLWranglerForums.com member Redrockjk recently purchased a used Wrangler hood from a yard near the FCA proving grounds. When he ordered it, he thought it was from a 2014 model, and while it looked very similar to his current hood, after installing he discovered something unusual. It was too long. From what we can see in the photos from JLWranglerForums.com, the leading edge of the hood sticks out roughly two inches from the top of the Wrangler's grille. The greater length is also clear when the hood is placed next to its likely predecessor. The receivers for the exposed latches are also too far forward to be used on a current Wrangler. Redrockjk also said there wasn't a VIN or a part number anywhere on the hood. As if those details weren't a big enough red flag, Redrockjk reported that the used parts supplier contacted him to ask for the hood back. We reached out to Jeep to see if they could confirm if this is a hood for the next-generation Wrangler. Unsurprisingly, the company had no comment at this time. Considering the details, and the proximity of the scrapyard to an FCA proving ground, there's a better than zero chance this is from a pre-production 2018 Wrangler sent to the yard to be scrapped. No word on whether the hood was aluminum, as has been rumored. Except for the length, the part fits pretty well on the current model. The hood vents present are also similar to those found on some current models. It's one more piece of evidence that the next Wrangler won't stray far from a proven formula. Related Video: Featured Gallery 2018 Jeep Wrangler Hood News Source: JLWranglerForums.comImage Credit: JLWranglerForums.com Spy Photos Jeep SUV Off-Road Vehicles forum wrangler forums