2014 Jeep Cherokee Latitude on 2040-cars

Auto blog

NHTSA closes book on Jeep 'trailer hitch' recall after all

After much debating and hand-wringing, the National Highway Traffic Safety Administration now says it has "no reservations" with Chrysler's plan to recall certain Jeep Liberty and Grand Cherokee models over concerns that their fuel tanks, which are located behind the rear axle, could rupture or leak in the event of a rear impact. The longstanding argument between the two entities saw Chrysler openly defy the Feds after a request to recall 2.7 million units back in June.
Chrysler's "voluntary campaign" will instead see it recall 1.56-million 1993-2004 model year Grand Cherokee SUVs, along with 2002-2007 Liberty models. Affected vehicles will get a trailer hitch installed free of charge, which Chrysler says will provide an additional degree of protection for the fuel tanks in the event of a crash. Jeeps with Mopar-branded hitches or hitches that were installed at the factory aren't affected by this recall.
Chrysler's argument throughout this battle has been that the Jeeps in question are no more susceptible to fires than comparable vehicles from the same time period, a position that NHTSA has seemingly arrived at as well. "Those vehicles performed at a rate similar to their peers. That is the keystone analysis as to whether something poses an unreasonable risk to safety," said outgoing NHTSA boss David Strickland during an interview with the The Associated Press.

Buy this instead of a Wrangler | 2017 Jeep Grand Cherokee Trailhawk Review

In our first encounter with the 2017 Jeep Grand Cherokee Trailhawk at Fiat Chrysler's Chelsea Proving Grounds, we saluted the new model's impressive on-road demeanor. In its off-road mode, however, we couldn't ignore the pre-production throttle calibration – it was super sharp and difficult to modulate with the precision needed to navigate obstacles. We were told then that Jeep's engineers were aware of the problem and were fixing it for production models. So we recently set off for Bundy Hill Off-Road Park in Jerome, Michigan, in a production-spec Grand Cherokee Trailhawk to check their work and get a better idea of the overall package. We can report that the Trailhawk's throttle has been fixed for production, landing it properly in Goldilocks territory. In the off-road Mud setting, the throttle is soft and easy to modulate. You can balance this rig with the gas pedal, reaching just past tip-in to steadily prod forward. But the gas pedal doesn't delay when you really need power. Move beyond the initial tip-in, and the engine responds quickly, which is a good thing, as a sluggish throttle is almost as dangerous off-road as one that's too sharp. Rock mode promises even more precise control over the throttle, although our lack of a spotter and a desire to avoid damaging the 700-mile-young Trailhawk kept us from hitting Bundy Hill's rockier sections. The wet, non-snowy weather meant we didn't properly test Snow or Sand mode. This test model was equipped with FCA's popular 3.6-liter V6, but like the rest of the Grand Cherokee range, more power is available from the 3.0-liter EcoDiesel V6 and the 5.7-liter Hemi V8. You don't need them – the 3.6-liter and eight-speed automatic are perfectly fine on the trails. Faced with an incline, the transmission holds its gear without complaint – you don't even need to switch into manual mode. Despite the 4,800-rpm torque peak, the V6's 260 pound-feet arrive early enough that you don't need to strong-arm the throttle. So that's resolution for the pre-production issue. But our time at Bundy Hill exposed a different and ultimately much easier to fix problem for the production model. Late fall in Michigan is not always a good time to go off-road – sub-40-degree temperatures and a steady, depressing drizzle can turn a relatively simple trail into a slippery mess of wet clay. Conditions like these can easily overwhelm an on-road tire like the Goodyear All-Terrain Adventures the Trailhawk uses.

Jeep readying 2018 and 2019 Wrangler recall for bad frame welds

According to documents posted to the JL Wrangler Forums, Jeep is readying a recall for an unknown number of 2018 and 2019 model-year Wrangler SUVs. The issue revolves around the track bar mount, which on some vehicles is shearing off where it is welded to the frame. Since some affected vehicles may be unsold on dealer lots, the automaker has issued a corresponding stop sale. A Jeep spokesperson confirmed to CNET that there have been no reported accidents related to the issue, and Jalopnik reports that Jeep will inspect roughly 18,000 vehicles for the defect, though it believes only around 720 will be affected. As of the time this story was published, the National Highway Traffic Safety Administration had not yet posted this recall to its website. There have been a total of five recalls for the 2018 Jeep Wrangler, including one for a steering shaft that could separate due to improper welding. One 2018 Jeep Wrangler owner in North Carolina posted a video to YouTube, seen above, showing track bar mounts that have completely sheared away from the vehicle's frame. These broken welds may cause severe steering degradation and "can cause a vehicle crash without prior warning," according to a dealer notice that was posted to the JL Wrangler Forum. That owner has said Jeep is replacing his Wrangler, but it's not clear if other vehicles are being replaced or repaired. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.