on 2040-cars

Auto blog

Georgia judge slashes verdict to $40M in Jeep fire case

A judge in Georgia has drastically reduced the damages that Fiat Chrysler Automobiles will have to pay to the family of Remington Walden, who a court said died as a result of the unsafe design of one of its vehicles. While the jury originally awarded the family $150 million at FCA's expense, Judge J. Kevin Chason cut that amount to $40 million, the Detroit News reported. The automaker may still appeal the verdict. The case dates to March 2012, when a 1999 Jeep Grand Cherokee in which four-year-old Walden was riding was rear-ended by another vehicle. Due to what the jury ruled was an unsafe fuel tank, a fire erupted, and Walden died in the fire. The family's lawyers successfully argued that the automaker knew there was a problem and didn't take sufficient action to address the issue, while FCA countered that its vehicles met the applicable safety standards when they were built. The jury found FCA 99 percent responsible for the fire and Walden's death, reserving the final one percent for the driver who caused the crash. The court awarded the Waldens $150 million in damages to be paid by the automaker: $120 million for wrongful death, and a further $30 million for pain and suffering. FCA, however, argued that the damages were disproportionate to the incident, noting that the $120 million was 11 times higher and the $30 million four times higher than any comparable awards upheld on appeal in the state. Chason agreed and cut the penalties extensively. The Walden family has reportedly accepted the reduced verdict. But according to the News, company spokesman Michael Palese said, "The reduction in the damage awards does not cure the many errors that tainted this verdict and denied FCA US a fair trial. We are considering our legal options." News Source: The Detroit NewsImage Credit: Jeep Government/Legal Recalls Jeep lawsuit court

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Stellantis reveals STLA Large platform with EV and ICE support

Hot on the heels of a Jeep Wagoneer S teaser and photos of the prototype next-generation Dodge Charger (or Challenger), comes a reveal and details of what will likely underpin both of them: the STLA Large platform. It's one of multiple Stellantis flexible architectures that will be the basis of its upcoming electric cars, and apparently internal combustion ones, too. Stellantis says the STLA Large platform will be for D- and E-segment cars, crossovers and SUVs. In other words, it will be for midsize and large vehicles. For reference, lengths supported will be from 187.6 to 201.8 inches, and width will range from 74.7 to 79.9 inches. It will be highly flexible, too, with Stellantis claiming significant amounts of adjustability in overhangs, wheelbase, suspension placement and powertrain arrangement. The powertrain flexibility is quite impressive. Front-, rear- and all-wheel-drive layouts will be supported. Single- and dual-motor layouts will be on offer. Internal combustion will be available, too, either on its own or as a hybrid. Apparently engines can be fitted either longitudinally or transversely, too. Battery packs with between 85 and 118 kWh of capacity will be offered, with Stellantis claiming that sedan-style vehicles could have a range of up to 500 miles. The packs will also be available in 400- and 800-volt designs. Stellantis noted also that the platform can "easily accept future energy storage technologies when they reach production readiness." This seems to hint that the company is looking at different battery chemistries and maybe even solid-state batteries that could be added more easily in the future. Furthermore, the platform is designed to handle impressive output. Stellantis says that some models on the platform will have 0-to-62 mph times in the 2-second range. Limited-slip differentials for improved power delivery and wheel-end disconnects for reduced mechanical drag are also on the table for this platform. All of these details fit well with the information previously given for the concept Dodge Charger Daytona Banshee and Jeep Wagoneer S. The former was previewed with both battery voltage architectures and a wide range of electric powertrains with between 456 and 670 horsepower depending on specification and upgrades. And that's just for the 400-volt system; the 800-volt option wasn't detailed. We've also seen photos of the Charger chassis seemingly with provisions for gas engines, likely versions of the Hurricane I6.