2014 Jeep Grand Cherokee Limited on 2040-cars

Auto blog

Fires, deaths continue after Jeep fuel tank recall

As Kayla White slowed her SUV behind two other cars to exit a suburban Detroit freeway on Veterans Day, it was rammed from behind by a Cadillac STS. Her red 2003 Jeep Liberty bounced off a Nissan in front of it, rolled onto its side and exploded in flames. Other drivers ran to help but were forced back by the heat. Firefighters arrived in just three minutes but were too late. White, a 23-year-old restaurant hostess who was eight months pregnant, died of burns and smoke inhalation. White is one of more than 70 people killed in fires involving older Jeeps with plastic fuel tanks mounted behind the rear axle. Fiat Chrysler, which makes Jeeps, recalled 1.56 million of them in June 2013 under pressure from US safety regulators. But only 12 percent of the SUVs have been repaired in the 18 months since the recall, a much slower pace than usual. And White's Jeep was not among those fixed. Last week, prosecutors charged the Cadillac driver with committing a moving violation that caused a death. But safety advocates and the lawyer for White's family say the blame belongs as much, if not more, on Chrysler and an auto-industry safety system that moves too slowly to prevent tragedy. The rear-mounted tanks have little structure to protect them if struck from behind, making them susceptible to punctures and fires. Moving the gas tank in front of the axle would be expensive and difficult. So Chrysler's remedy involved installing trailer hitches on the rear of the Jeeps as an extra layer of protection. Government testing showed the hitches protected the tanks in crashes up to 40 mph when stationary Jeeps were hit from behind. But at higher speeds, they wouldn't help. White tried to get the repair done a few weeks before her death but was told by a Jeep dealer that parts weren't available, according to Gerald Thurswell, her family's lawyer. He wouldn't identify the dealership, and his contention could not be independently verified by The Associated Press. Thurswell contends the gas tank ruptured, spilling fuel that touched off the fire. A Chrysler spokesman expressed sympathy to White's family but said the company had no written proof that she asked a dealer about the recall. Two crash reconstruction experts interviewed by the AP say gas wouldn't have spilled from White's Jeep if the tank had been mounted in front of the rear axle. Both say a hitch might have prevented the tank from being damaged, but because both vehicles were in motion, neither expert could say for sure.

First Jeepster prototype spotted with final, boxy form

The long-awaited baby Jeep is getting closer to production, as evidenced by these spy photos. Previously, the only images of the so-called Jeepster saw it wearing a Fiat 500L body (see below), while this new batch of photos show hefty amounts of camouflage. How is that better? Well, it's very likely there's a production body hiding under all that cladding.
While picking out styling details is virtually impossible thanks to all the camo, as our spies point out, this gives us a very sound idea of the Jeepster's final size. It's small, although we'd argue that it's only slightly smaller than the current Jeep Patriot, based on the images of the newest Jeep sitting in front of an Alfa Romeo Giulietta.
As we reported previously, this little bambino will be built on a Fiat platform, but the styling should be uniquely Jeep - likely to include a somewhat vertical seven-slat grille and round headlights. We can expect to see a production Jeepster, if that ends up being the actual name (Latitude has been rumored, although as that's traditionally a trim level, we imagine there'd be some confusion), when it debuts at the 2014 Geneva Motor Show.

FCA to invest $4.5B for new Detroit plant, expanded production at current facilities

We expected some shifts in manufacturing plans as Fiat Chrysler plans to begin electrifying its Jeep brand, but this news bodes well for Michigan. FCA announced today that it would spend $4.5 billion to expand production in the state, including building a new assembly plant in Detroit and increasing capacity at five other facilities in the state. The plan, which FCA says will create nearly 6,500 new jobs, will help to meet increasing demand for Ram and Jeep products, and to electrify Jeep models. $1.6 billion will be set aside to transform the Mack Avenue Engine Complex into a site to build the next generation of Jeep Grand Cherokee, as well as an unspecified, new three-row Jeep model. FCA says this part of the plan will create 3,850 new jobs. FCA is increasing its investment in the Warren Truck plant to $1.5 billion in order to continue building the Ram 1500 Classic, as well as the new Jeep Wagoneer and Grand Wagoneer, creating 1,400 new jobs. FCA says that the new Ram 1500 Heavy Duty will still be built in Saltillo, Mexico. At FCA's Jefferson North facility, the automaker will invest $900 million to upgrade the plant. This site will continue to build the Dodge Durango, as well help build the next Jeep Grand Cherokee. FCA expects this to create 1,100 new jobs. As Jeep plans to electrify models in its SUV lineup, each of the above plants will produce plug-in hybrid versions of the Jeep models produced there, "with flexibility to build fully battery-electric models in the future," the company said in its announcement. "Three years ago, FCA set a course to grow our profitability based on the strength of the Jeep and Ram brands by realigning our U.S. manufacturing operations," said FCA CEO Mike Manley, referring in part to earlier investments in Illinois, Ohio and Michigan. "Today's announcement represents the next step in that strategy," Manley continued. "It allows Jeep to enter two white space segments that offer significant margin opportunities and will enable new electrified Jeep products, including at least four plug-in hybrid vehicles and the flexibility to produce fully battery-electric vehicles." Other investments include $119 million to move production of the 3.0-, 3.2- and 3.6-liter Pentastar engines from Mack I to the Dundee Engine Plant, and $400 million for increased capacity and 80 new jobs at the Sterling and Warren stamping plants. This comes at a time when FCA's U.S.