2013 Jeep Wrangler Sahara 4wd Rebuilt Salvage Title, Rebuidable Repaired Damage on 2040-cars

Auto blog

Buy this instead of a Wrangler | 2017 Jeep Grand Cherokee Trailhawk Review

In our first encounter with the 2017 Jeep Grand Cherokee Trailhawk at Fiat Chrysler's Chelsea Proving Grounds, we saluted the new model's impressive on-road demeanor. In its off-road mode, however, we couldn't ignore the pre-production throttle calibration – it was super sharp and difficult to modulate with the precision needed to navigate obstacles. We were told then that Jeep's engineers were aware of the problem and were fixing it for production models. So we recently set off for Bundy Hill Off-Road Park in Jerome, Michigan, in a production-spec Grand Cherokee Trailhawk to check their work and get a better idea of the overall package. We can report that the Trailhawk's throttle has been fixed for production, landing it properly in Goldilocks territory. In the off-road Mud setting, the throttle is soft and easy to modulate. You can balance this rig with the gas pedal, reaching just past tip-in to steadily prod forward. But the gas pedal doesn't delay when you really need power. Move beyond the initial tip-in, and the engine responds quickly, which is a good thing, as a sluggish throttle is almost as dangerous off-road as one that's too sharp. Rock mode promises even more precise control over the throttle, although our lack of a spotter and a desire to avoid damaging the 700-mile-young Trailhawk kept us from hitting Bundy Hill's rockier sections. The wet, non-snowy weather meant we didn't properly test Snow or Sand mode. This test model was equipped with FCA's popular 3.6-liter V6, but like the rest of the Grand Cherokee range, more power is available from the 3.0-liter EcoDiesel V6 and the 5.7-liter Hemi V8. You don't need them – the 3.6-liter and eight-speed automatic are perfectly fine on the trails. Faced with an incline, the transmission holds its gear without complaint – you don't even need to switch into manual mode. Despite the 4,800-rpm torque peak, the V6's 260 pound-feet arrive early enough that you don't need to strong-arm the throttle. So that's resolution for the pre-production issue. But our time at Bundy Hill exposed a different and ultimately much easier to fix problem for the production model. Late fall in Michigan is not always a good time to go off-road – sub-40-degree temperatures and a steady, depressing drizzle can turn a relatively simple trail into a slippery mess of wet clay. Conditions like these can easily overwhelm an on-road tire like the Goodyear All-Terrain Adventures the Trailhawk uses.

Chrysler investing $20M in Toledo plant to support 9-speed auto production

In 2011, Chrysler announced a $72-million investment in its Toledo Machining Plant to modernize production of the eight- and nine-speed torque-converters for automatic transmissions made there. That upgrade work won't be finished until Q3 of this year, but Chrysler has already announced a further $19.6-million investment to increase production capacity for the nine-speeders.
The extra units will be necessary because the nine-speed transmission they'll be mated to is going into three popular models: it will debut on the 2014 Jeep Cherokee, then go into the Chrysler 200 and Dodge Dart. The company predicted that this year alone it would sell 200,000 units equipped with the nine-speed tranny, and it is spending some $374 million in addition to the investment in Toledo to upgrade production capacity for it.
The work attached to this new investment won't begin until Q3 of 2014, and it will be finished by the end of that year. There's a press release below with all the details.

Weekly Recap For 5.20.16 | Autoblog Minute

Senior Editor Greg Migliore recaps the week in automotive news, including a look at the Aston Martin Vanquish Zagato, two Volvo concepts, and the FCA Jeep airbag recall.