1964 Jeep Cj 2drcv 4 Wd on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

BMW M850i Coupe, Jeep Wrangler Rubicon and a 1996 Toyota Land Cruiser | Autoblog Podcast #585

In this week's Autoblog Podcast, Editor-in-Chief Greg Migliore is joined by Senior Editor Alex Kierstein and Senior Editor, Green, John Snyder. This week, they talk about driving the BMW 8 Series Coupe, Jeep Wrangler Rubicon and Toyota Corolla Hatchback. Then they talk about the news, including electric Hummer rumors and Tesla pickup timing. Finally, they consider whether or not Greg should buy his neighbor's 1996 Toyota Land Cruiser. Autoblog Podcast #585 Get The Podcast iTunes – Subscribe to the Autoblog Podcast in iTunes RSS – Add the Autoblog Podcast feed to your RSS aggregator MP3 – Download the MP3 directly Rundown Cars we're driving: BMW M850i xDrive Coupe Jeep Wrangler Rubicon Toyota Corolla Hatchback In the news: Is an all-electric Hummer in the works? Tesla pickup truck is on its way Spend My Money: 1996 Toyota Land Cruiser Feedback Email – Podcast@Autoblog.com Review the show on iTunes Related Video:

FCA's U.S. sales chief sues company for wrongful retaliation

Some fresh controversy is brewing at Fiat Chrysler Automobiles as The Detroit News reports that the head of U.S. sales has filed a federal whistleblower lawsuit against the company.. Reid Bigland, who's also in charge of the Ram truck brand, alleges that FCA made him a scapegoat for wrongful sales inflation practices and fixing vehicle sales statistics, which are currently under investigation by federal agents. Bigland claims that FCA executives punished him for cooperating with the federal investigators in the case by cutting his pay by more than 90 percent, according to the lawsuit he filed. The plan apparently was to use the money saved to pay for fines following any settlements made with the Securities and Exchange Commission. So far, the lawsuit alleges that FCA cost Bigland over $1.8 million in income. "They had the largest growth in retail sales in 17 years last year and refuses to pay him," Deborah Gordon, Bigland's lawyer in the case, said to The Detroit News. "Why is that? Because he participated in the SEC investigation and they don't like what he said." Bigland claims he just cooperated with the SEC investigation by testifying about FCA's sales reporting, from the time he took the position to the period prior to being appointed the company's U.S. sales chief. "In late 2018, presumably as a way to wrap up their investigation with some result, the SEC suggested to plaintiff that he admit to some wrongdoing as to defendants' monthly sales reporting," Gordon further said in a statement as part of the lawsuit. "The SEC also suggested a resolution involving some penalty to FCA. Because (Bigland) had not engaged in any wrongdoing, and there was no wrongdoing, he declined to do so." However, exacerbating the issue is the fact that Bigland reportedly sold his shares in the company last year, prompting FCA to act against him even more. FCA came under fire recently by federal agents in at least two separate investigations, potentially exposing conspiracy and corruption between company executives and private entities. The investigations are being led independently by the U.S. Attorney's Office and the FBI. So far, eight convictions were reportedly secured, with one including former Fiat Chrysler Automobiles Vice President Alphons Iacobelli, as one of the defendants. Iacobelli was one of the former top labor-relations executives for the automaker.