2007 Jaguar Xk Xk Convertible on 2040-cars

Auto blog

Driving Jaguar's Continuation Lightweight E-Type

Something has happened to sports cars over the past 15-20 years. While reaching ever-higher levels of quantitative dominance the driving experience continues to become more sterile. Stability control, torque vectoring, variable electronic steering racks, lightning-quick dual-clutch automatic transmissions – all these make it easier to harness more power and drive faster than ever before. And yet too often it feels like something is missing. There is a growing divide between the capabilities of the modern performance car and the driver's sense of connection to the experience. In an era like the one we're in now, the Jaguar Lightweight E-Type hits you like a slap in the face. The story of the Lightweight E-Type goes back to 1963, when Jaguar set aside eighteen chassis numbers for a run of "Special GT E-Type" cars. These were factory-built racers with aluminum bodies, powered by the aluminum-block, 3.8-liter inline-six found in Jaguar's C- and D-Type LeMans racecars of the 1950s. Of the eighteen cars slated for production, only twelve were built and delivered to customers in 1964. For the next fifty years, those last six chassis numbers lay dormant, until their rediscovery a couple of years ago in a book in Jaguar's archives. In an era like the one we're in now, the Jaguar Lightweight E-Type hits you like a slap in the face. Jaguar Heritage, a section of Jaguar Land Rover's new Special Vehicle Operations (SVO) division, took on the task of researching the original Lightweight E-Types and developing the methods to create new ones. Every aspect of the continuation Lightweight E-Type, from the development of the tools and molds used to build the cars, to the hand-craftsmanship, reflects doing things the hard way. They may not build them like they used to, but with these six special E-Types, Jaguar comes awfuly close, if not better. Working alongside the design team, Jaguar Heritage made a CAD scan of one side of an original Lightweight E-Type body. That scan was flipped to create a full car's worth of measurements. That ensured greater symmetry and better fit than on the original Lightweight E-Types (which could see five to ten millimeter variance, left-to-right). The scan was also used to perfect the frame, while Jaguar looked through notes in its crash repair books to reverse-engineer the Lightweight E-Type's suspension. The team repurposed a lot of existing tooling for the continuation cars, and developed the rest from analysis of the CAD scan.

Jaguar practiced the E-Pace barrel roll - wait, how do you practice a barrel roll?

Jaguar launched the E-Pace compact crossover by literally launching it into a barrel roll. But to get to the point where the company could do the stunt in front of the press naturally took plenty of preparation and planning, and the company documented much of it in the video above. It turns out that the early stages of preparing the stunt are about as entertaining as the stunt itself. The video spends a little time showing some of the computer modeling and designing of the stunt, but most of the video covers the practice runs done with a test car. Jaguar set up its prototype offset ramp for initiating the roll, and had a massive airbag set up for the test car to land in. And early on, to make sure the stunt driver wasn't hurt, they rigged up a Land Rover Evoque with autonomous driving equipment to do the first runs. Later the stunt driver took a few turns. The testing resulted in flips and tumbles you've only seen with Hot Wheels cars. It's so strange and fun to see a full-size car launched this way. Once the team finally had the jump pretty well dialed in, the stunt driver was able to test it launching from ramp to ramp, and then eventually do it in the production E-Pace at the crossover's reveal. Related Video: Image Credit: Jaguar Jaguar Crossover Luxury Videos jaguar e-pace

Jaguar Project 7 concept is an F-Type in a D-Type mold [w/video]

In addition to the XJR, XFR-S and XKR-S GT models Jaguar is bringing to the Goodwood Festival of Speed this weekend, the manufacturer announced that the F-Type-based, D-Type-inspired Project 7 design study will make its "dynamic" debut at the festival, with driving duties assigned to Mike Cross, Jaguar's chief engineer of vehicle integrity. Here's the cool part: With Jaguar's Director of Design, Ian Callum, leading the team responsible for Project 7, it went from the drawing board to track testing in only four months, Jaguar states, with a claimed 0-60 time of 4.1 seconds and top speed of 186 miles per hour.
Project 7, which was named in honor of Jaguar's seven wins at the 24 Hours of Le Mans, will be making runs up the hill at Goodwood over all three days of the festival, which starts at the Goodwood House in West Sussex, England, this Friday.
Far from a fragile concept car, Jaguar says, the single-seat Project 7 is a fully functional sports car. It uses the all-aluminum chassis and body of the F-Type, retains that car's 550-horsepower, supercharged 5.0-liter V8 and eight-speed automatic transmission but features lots of bespoke carbon fiber aerodynamic bits, some of which were inspired by the Le Mans-winning D-Type of the 1950s. The most obvious nod to that classic is the rear fairing with integrated rollover hoop - the F-Type's convertible top is gone. The windshield was also lowered, giving the roadster a more rakish silhouette as it sits on 20-inch forged-alloy wheels with carbon fiber inserts.