2014 Honda Civic Si on 2040-cars

Auto blog

It turns out Takata isn't willing to expand airbag recall nationally after all

There have been "approximately 0.000006 failures per air bag deployment, which is far below the failure rate" of most recalls, Takata claims. Takata has seemingly made an about face following reports that it would expand its regional airbag recall into a nationwide repair effort, issuing a scathing, four-page letter rebutting allegations by the National Highway Traffic Safety Administration and its Office of Defects while simultaneously attacking the government's handling of the situation. The Japanese supplier claims in its letter that the "currently available, reliable information does not support a nationwide determination of a safety defect," arguing that there were "approximately 0.000006 failures per air bag deployment, which is far below the failure rate in the vast majority of the thousands of recalls," The Detroit News reports. Takata then breaks down the two specific incidents mentioned in NHTSA's original recall request letter, a 2005 Honda Accord and 2007 Ford Mustang. Referencing the two crashes, NHTSA Administrator David Friedman said last month "one incident is an anomaly, but two are a trend." The supplier, though, argues the Honda issue is already being covered by that company's soon-to-be-national recall (more on that in a moment). The company then goes on to point out that neither Takata nor NHTSA has been able to analyze the Mustang's airbag inflator, saying that such a lack of examination meant there was "no way to ascertain what actually occurred during the incident, whether any inflator ruptured, and whether any inflator rupture that may have occurred was related to the incidents that led to the current regional campaigns." Takata alleges that NHTSA has disobeyed its own statutes. Takata also took the opportunity to take a few swipes at NHTSA's behavior during the airbag scandal, saying it was "very surprised to receive" a recall request letter because the ODI had yet to even receive the company's responses to a pair of special orders. It also alleged that NHTSA was disobeying its own statute, which says only manufacturers of vehicles and replacement equipment can "decide in good faith whether their products contain a safety related defect," and that the government can only "issue an initial decision that a safety-related defect exists" to those same entities.

22,000 Honda Shadow 750 motorcycles recalled [UPDATE]

Update: Honda's statement on the recall is now embedded below. The Basics: Honda will recall 22,142 examples of its 2010-2016 VT750 Shadow motorcycles, including the 2012-2014 VT750CA, VT750C2 and VT750C2F; 2011-2016 VT750C; 2013-2016 VT750CS; 2010-2016 VT750C2B; and 2013-2014 VT750C2S. The Problem: Engine vibration can cause a wire for the bank angle sensor to rub against the joint connector on the wire harness. This can eventually cause a loss of the signal, and the engine could stall. Injuries/Deaths: None reported. The Fix: Dealers will replace the bank angle sensor and move the joint connector. If You Own One: Honda expects the recall to begin February 19. More Information: Documents from the National Highway Traffic Safety Administration (as a PDF) report Honda received five warranty claims and five field reports about this issue as of December 14, 2015. Related Video: RECALL Subject : Engine Stall from Loss of Sensor Signal Report Receipt Date: DEC 23, 2015 NHTSA Campaign Number: 15V874000 Component(s): ELECTRICAL SYSTEM Potential Number of Units Affected: 22,142 All Products Associated with this Recall Vehicle Make Model Model Year(s) HONDA VT750 2010-2016 Details Manufacturer: Honda (American Honda Motor Co.) SUMMARY: Honda (American Honda Motor Co.) is recalling certain model year 2012-2014 VT750CA, VT750C2 and VT750C2F, 2011-2016 VT750C, 2013-2016 VT750CS, 2010-2016 VT750C2B and 2013-2014 VT750C2S motorcycles. Engine vibration may cause the bank angle sensor wire to rub on the wire harness joint connector, resulting in a loss of the sensor signal. CONSEQUENCE: Without the bank angle sensor signal, the engine may stall while riding, increasing the risk of a crash. REMEDY: Honda will notify owners, and dealers will relocate the joint connector and replace the bank angle sensor, free of charge. The recall is expected to begin February 19, 2016. Owners may contact Honda Motorcycle customer service at 1-866-784-1870. Honda's number for this recall is JW7. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. American Honda Statement on VT750 Recall Honda has issued a Safety Recall of some 2010-2016 model-year VT750 motorcycles. It is possible that long term exposure to engine vibrations may cause the bank angle sensor wiring to break, or be damaged, which could cause the engine to stall and increase the risk of a crash.

Honda recalls nearly 10,000 new Civic models over pinched tires

Honda is recalling some 9,816 Civic LX coupes and sedans from the 2014 model year due to a potential tire problem.
According to a National Highway Traffic Safety Administration notice, the safety problem stems from an installation problem at a supplier, which may have caused the tire bead to become pinched between the steel wheel and the mounting equipment. As a result, tire beads may have been damaged, which could result in a loss of pressure, a condition that could lead to an increased accident risk, or at least an increased risk of being stranded and late for work.
Honda spokesperson Chris Martin tells Autoblog, "Only about 1,800 of that 9,800 have been sold because we caught it so quickly. The majority of them were in transit or unsold at dealers."