2002 Gmc Yukon on 2040-cars

Auto blog

The Hummer EV Edition 1 is sold out and it'll be years before other trims arrive

When the 2022 GMC Hummer EV was revealed, GMC noted that there would be lower trims available. The company has since provided a few more details on those lower trims, which is helpful to know now that the only trim on sale next year, the Edition 1, was sold out in a scant 10 minutes. However, it's going to be a long time before they're all available.  The entry-level GMC Hummer EV is the EV2. This is the model that will start at $79,995, and unlike the Edition 1, it gets just two motors, one for each end of the truck, each with electronically locking differentials. Output is down to 625 horsepower and a torque rating of 7,400 pound-feet. Note that this and all other reported torque numbers are after the torque multiplication by the single-speed transmissions, hence the extremely high numbers. The company hasn't given torque numbers at the motors, which would be more comparable to other electric cars. Range is also reduced to 250 miles, probably due to a smaller battery pack. Fast charging is also restricted to 400-volt charging, so it won't be as fast as the higher trim models. The removable roof panels, retractable rear window, MultiPro tailgate, Super Cruise and 35-inch tires are standard. This model only gets fixed steel suspension and two-wheel steering. The EV2 will be the last of the trim levels to go on sale, with a target of spring 2024. Yes, as in 3.5 years from now.  The next level is the EV2X, which will be available a year earlier in the spring of 2023. It gets the same powertrain as the EV2, but adds 800-volt fast charging and a 300-mile range. It also gets the adaptive air suspension and four-wheel steering, plus the associated party tricks of Crab Mode and Extract Mode. This model costs $89,995. The earliest Hummer EV that isn't an Edition 1 and therefore not yet sold out will be the EV3X, the entry-level three-motor model. It goes on sale in the fall of 2022 at a price of $99,995. It's not quite as potent as the Edition 1, though, with an output of 800 horsepower and 9,500 pound-feet of torque. It also lacks the "Watts to Freedom (WTF)" launch control feature. But it does get torque-vectoring with the dual rear motors, which can also lock their speeds to be equal like with the mechanical locking differential at the front. The EV3X's range is 300 miles like the EV2X.  As for the Edition 1, it started $112,595 before it was sold out. Customers are to expect them in fall 2021.

GM recalls select Tahoes, Yukons, Escalades for rear driveshaft issue

GM is recalling a number of its full-size SUVs due to an issue with the rear driveshaft assembly that could ultimately result in driveshaft failure. The actual number of total vehicles involved in the recall is small at just 1,789, but it’s spread out across the entire 2021 model year full-size GM vehicle lineup. That means a small number of every model is being recalled, including the Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL and the Cadillac Escalade and Escalade ESV. GM traced the issue back to certain driveshaft assemblies with ball bearings that were not properly heat treated. If theyÂ’re not properly heat treated, GM says that the balls may deform over time, causing noise and vibration. Continue to drive in this condition, and GM says the affected joint in the driveshaft assembly could seize, causing loss of drive power. However, the problem wonÂ’t present itself all at once, as GM says there will be a gradual increase of noises and vibrations before total failure. For those few owners with affected vehicles, GM says that it will replace the left and right rear driveshaft assemblies with properly-built units. Per usual with recalls, this will be done at your local dealership at no cost to the owner. If you have one of the recalled SUVs, expect to be notified mid-March. Related video:

GM plans to restart production in Mexico on May 20

MEXICO CITY — General Motors is tentatively planning to restart operations at its auto assembly plant in the Mexican city of Silao on May 20, according to a message to workers seen by Reuters on Sunday, as the car industry prepares to exit the coronavirus lockdown. Separately, the president of GM's Mexican unit advised suppliers to prepare to resume operations. “We are now beginning a new phase given the Mexican governmentÂ’s official announcement earlier this week to consider the transportation manufacturing industry as essential for the countryÂ’s economy,” Francisco Garza, president ofGeneral Motors de Mexico, wrote in an email to suppliers dated on Friday that was viewed by Reuters. The reopening of the plant  in Silao would be a positive signal for the auto sector in North America, whose supply lines are highly interconnected between the United States, Mexico and Canada. The plant in the central state of Guanajuato has been idled for weeks due to the coronavirus outbreak. Workers had previously been told to plan to return to their jobs on May 18. A GM spokeswoman said the company could not confirm when it would restart operations at any of its facilities in Mexico because it is awaiting more guidance from the government. The message to the plant's workers came after the government on Friday clarified when the industry could begin easing restrictions imposed because of the health emergency. On Wednesday, the government said automakers could start going back into production from May 18. It then withdrew that advice and suggested the new start date would be June 1. Finally it indicated the sector, which forms the backbone of Mexican manufacturing, could begin operating as soon as next week if companies had the required safety measures in place. U.S. officials and its auto industry have pressed Mexico's government to get its factories open again because American operations depend heavily on parts from south of the border. However, some politicians are wary of opening too fast. Mexico registered its first case of coronavirus weeks after the United States and Canada and the toll of daily infections and deaths in the country reached new peaks over the past few days. The Silao production facility, which makes highly profitable pickup trucks for GM, is one of the biggest automotive plants in Guanajuato, a major Mexican carmaking state. Related Video: