2001 - Gmc Sierra 1500 on 2040-cars

Auto blog

GM will recall 3.5 million pickups and SUVs to fix brake issue

WASHINGTON — General Motors Co is recalling 3.46 million U.S. pickup trucks and SUVs to address a vacuum pump issue that could make braking more difficult and increase the risk of a crash. The recall, which covers 2014-2018 model year vehicles, including some Cadillac Escalade, Chevrolet Silverado, Chevrolet Tahoe, GMC Sierra, Chevrolet Suburban and GMC Yukon vehicles, was triggered because the amount of vacuum created by the vacuum pump may decrease over time, GM told the National Highway Traffic Safety Administration (NHTSA) in documents posted Wednesday. NHTSA opened a preliminary investigation into the issue in November 2018, and said it had reports of 9 crashes and two injuries related to the issue. It provided GM in July with additional field reports that prompted the automaker to open an investigation. The company did not immediately say on Wednesday how many injuries or crashes are linked to the issue but said it could impact braking in "rare circumstances." GM said dealers will reprogram the Electronic Brake Control Module with a new calibration that will improve how the system utilizes the hydraulic brake boost assist function when vacuum assist is depleted. GM said the vacuum assist pump, which is lubricated with engine oil that flows into the pump through a filter screen, can in some cases lose effectiveness over time, as debris such as oil sludge can accumulate on the filter screen. GM told NHTSA that prior model years used a different brake assist system design, and vehicles manufactured after 2018 were not equipped with the affected pump design. Recalls Chevrolet GM GMC

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM recalls nearly 1 million vehicles for airbag defect

WASHINGTON — General Motors said on Friday it will recall nearly 1 million sport utility vehicles in the United States because the driver's airbag inflator may explode during deployment. The recall covers 994,763 Buick Enclave, Chevrolet Traverse, and GMC Acadia vehicles from the 2014 through 2017 model years with modules produced by ARC Automotive Inc. Dealers will replace the driver's airbag module. The National Highway Traffic Safety Administration said a driver in Michigan of a 2017 Chevrolet Traverse was in a crash in which the front-driver airbag inflator ruptured during deployment causing facial injuries. An April 25 inspection confirmed that the front driver airbag inflator ruptured in the vehicle. The National Highway Traffic Safety Administration (NHTSA) demanded the recall of 67 million air bag inflators because it believes there is a safety defect, but auto supplier ARC Automotive Inc rejected the U.S. regulator's request, documents released on Friday show. The auto safety agency said the inflators pose an unreasonable risk of death or injury. Even as ruptures mount, "ARC has not made a defect determination that would require a recall of this population," NHTSA said in its demand letter to the Tennessee-based company. "Air bag inflators that project metal fragments into vehicle occupants, rather than properly inflating the attached air bag, create an unreasonable risk of death and injury." GM said it was still investigating the issue with the assistance of a third-party engineering firm. "GM is taking this expanded field action out of an abundance of caution and with the safety of our customers as our highest priority," the Detroit automaker said. GM said it was aware of two prior ruptures of ARC-manufactured airbag inflators in 2015 Chevrolet Traverse vehicles, and GM conducted two earlier small recalls of about 3,000 ARC inflators. All three rupture events in Chevrolet Traverse vehicles involved the same inflator variant. ARC noted in a letter made public Friday that no root cause for those ruptures has been identified by ARC or GM. ARC said it was assessing the scope of GMÂ’s recall.  Government/Legal Recalls Buick Chevrolet GMC Safety Crossover SUV