2019 Gmc Acadia Slt-1 on 2040-cars

Auto blog

GMC could have used Jeep's prized grille design on its born-again Hummer

General Motors confirmed it's bringing the Hummer nameplate back on an electric, GMC-badged pickup by publishing a dark photo of its front end. The battery-powered drivetrain under the sheetmetal represents a tectonic shift, but we noticed another flagrant break with tradition: it wears six slot-like inserts instead of seven like on every previous Hummer and countless Jeeps. Adding an extra slot wouldn't have landed GMC in hot water. The seven-slot grille has historically been associated with Jeep, and the company proved it's willing to go to significant lengths to ensure another automaker — especially one it perceives as a rival — doesn't use it. Parent company Fiat-Chrysler Automobiles (FCA) bitterly sued Mahindra over the Roxor's design, including its five-slot grille, and won in 2019, forcing the Indian firm to unveil a redesigned side-by-side for the 2020 model year. And yet, stylists would have very likely been able to get away with it on the Hummer. While General Motors owns Hummer, the brand traces its ancestry to 1970, when American Motors Corporation (AMC) purchased Jeep from Kaiser and changed the name of its General Products Division to AM General Corp. The division manufactured the rear-wheel drive, CJ-based DJ for the United States Postal Service and began developing the Humvee in 1979. Jeep and AM General went their separate ways when Renault began investing in AMC. Foreign companies weren't allowed to own defense contractors, and AMC had more to gain by gradually selling out to Renault than by keeping AM General, so it divested the division to LTV Corporation in 1983. Humvee production started shortly after, but no one protested its seven-slot grille because there was no risk of it stealing sales from a comparable Jeep model. It was manufactured exclusively for the U.S. Army, and civilian sales weren't planned. H2SUV View 4 Photos The original civilian Hummer released in 1992 must have raised more than a few eyebrows but, here again, it didn't directly compete with one of Jeep's off-roaders, so no one complained. It was huge, correspondingly expensive, and its portal axles made the YJ-generation Wrangler wet its pants. It's the H2 concept (pictured above) unveiled at the 2000 Detroit Auto Show that set off alarm bells in Auburn Hills. DaimlerChrysler's lawyers counted the slots in the chrome-plated insert that dominated its front end and shuddered when they reached seven.

Diesel details: Comparing Ram 1500 EcoDiesel, Chevy Silverado Duramax, Ford F-150 Powerstroke

With specifications for the 2019 Ford F-150 Power Stroke diesel already out, and the details on the 2020 Ram 1500 EcoDiesel and Chevy Silverado Duramax (and its GMC Sierra twin) trickling out, we felt it was a good time to start comparing the full-size trucks' light-duty diesels. Bear in mind, we've only driven one of these new diesel trucks, so we'll be sticking to numbers for now. Some numbers haven't been announced yet, either, but stay tuned, because we'll be updating this post with additional specifications as they become available. And if you want to compare any other versions of these trucks with other vehicles, be sure to check out our comparison tool. Now let's start comparing, starting with our big chart of numbers below. As we can plainly see, these trucks are quite closely matched. Each one has six cylinders, a displacement of 3.0 liters and a turbocharger to boost it. The output of each is somewhat close, too. The Ram 1500 EcoDiesel is the torque king at 480 pound-feet, 20 more than the GM trucks and 40 more than the Ford. The GM trucks win on power, though, with 277 ponies, 17 more than the Ram, and 27 more than the Ford. GM does report that you get their trucks' peak 460 pound-feet of torque from 1,500 rpm to 3,000 rpm, whereas the others only report peak torque at a particular point in the rev band, but all of these trucks should have wide, flat torque curves as you would expect from modern turbodiesels. 2020 Ram 1500 EcoDiesel View 8 Photos Engine output is only one part of the truck performance equation. We also have towing and payload capacity, as well as fuel economy. With towing, the Ram 1500 is the current leader with a maximum capacity of 12,560 pounds. That tops the Ford F-150's 11,400-pound tow rating by well over 1,000 pounds. The F-150 can carry 2,020 pounds in its bed, but we don't know yet whether that's better or worse than the Ram or the GM trucks. We also don't have numbers for the GM trucks' towing capacities. View 9 Photos As for fuel economy, the Ford F-150 manages a thoroughly impressive 22 mpg in the city and 30 on the highway with two-wheel drive. Choosing four-wheel drive drops those numbers to 20 and 25 respectively. The fuel economy numbers for the Ram, Chevy and GMC haven't been revealed yet, but for some comparison, we can look at the old Ram EcoDiesel. That truck's best fuel economy was 20 in the city and 27 on the highway with two-wheel drive.

GM plans to restart production in Mexico on May 20

MEXICO CITY — General Motors is tentatively planning to restart operations at its auto assembly plant in the Mexican city of Silao on May 20, according to a message to workers seen by Reuters on Sunday, as the car industry prepares to exit the coronavirus lockdown. Separately, the president of GM's Mexican unit advised suppliers to prepare to resume operations. “We are now beginning a new phase given the Mexican governmentÂ’s official announcement earlier this week to consider the transportation manufacturing industry as essential for the countryÂ’s economy,” Francisco Garza, president ofGeneral Motors de Mexico, wrote in an email to suppliers dated on Friday that was viewed by Reuters. The reopening of the plant  in Silao would be a positive signal for the auto sector in North America, whose supply lines are highly interconnected between the United States, Mexico and Canada. The plant in the central state of Guanajuato has been idled for weeks due to the coronavirus outbreak. Workers had previously been told to plan to return to their jobs on May 18. A GM spokeswoman said the company could not confirm when it would restart operations at any of its facilities in Mexico because it is awaiting more guidance from the government. The message to the plant's workers came after the government on Friday clarified when the industry could begin easing restrictions imposed because of the health emergency. On Wednesday, the government said automakers could start going back into production from May 18. It then withdrew that advice and suggested the new start date would be June 1. Finally it indicated the sector, which forms the backbone of Mexican manufacturing, could begin operating as soon as next week if companies had the required safety measures in place. U.S. officials and its auto industry have pressed Mexico's government to get its factories open again because American operations depend heavily on parts from south of the border. However, some politicians are wary of opening too fast. Mexico registered its first case of coronavirus weeks after the United States and Canada and the toll of daily infections and deaths in the country reached new peaks over the past few days. The Silao production facility, which makes highly profitable pickup trucks for GM, is one of the biggest automotive plants in Guanajuato, a major Mexican carmaking state. Related Video: