2003 Ford Taurus Ses 4 Door 3.0l V6 - No Dents, No Rust, Great Paint on 2040-cars

Auto blog

Fitting Retirement: Grand Marquis last Mercury off the line

The signs have come down and retail production ended back in October of 2010. Now, the very last Mercury model has rolled off the assembly line. This last Mercury somewhat fittingly takes the form of a Grand Marquis reporting for fleet duty. It was built at the St. Thomas plant in Ontario, Canada, which is the same facility that continues to produce the Ford Crown Victoria and Lincoln Town Car for fleet and livery duty.
St. Thomas' days are numbered, however, as the factory is slated to close on August 31. When it goes, the Panther platform is likely to follow. So long, and thanks for all the fish memories.
[Source: Autoweek]Read | Permalink | Email this | Comments

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford unveils all-new 2016 F-650 and F-750 at NTEA

Medium-duty work trucks might not be the most exciting vehicles, but they perform necessary jobs everyday. Ford is in the process of a complete refresh of its entire commercial vehicle lineup over the next 18 months, and it is debuting the all-new versions of its F-650 and F-750 trucks at the NTEA Work Truck Show in Indianapolis, IN.
"The all-new F-650/F-750 allow us to leverage our strengths and sales leadership in Classes 1 to 5 to create a better F-650/F-750 that's designed, engineered and built by Ford in the USA," said Ford spokesperson Mike Levine to Autoblog via email.
Huge amounts of torque is vital for trucks like these, and both models are offered with some of Fords biggest engines. Buyers can opt for either the 6.7-liter Power Stroke V8 diesel with TorqShift 6-speed automatic with available power takeoff or a gasoline-fueled 6.8-liter V10 with a 6-speed automatic. The V10 can also be ordered from the factory to be fueled by compressed natural gas or liquid propane gas.