Ford Mustang Base Coupe 2-door on 2040-cars

Auto blog

Defying Trump, major automakers finalize California emissions deal

WASHINGTON — The California Air Resources Board (CARB) and major automakers on Monday confirmed they had finalized binding agreements to cut vehicle emissions in the state, defying the Trump administration's push for weaker curbs on tailpipe pollution. The agreements with carmakers Ford Motor Co, Volkswagen AG, Honda Motor Co and BMW AG were first announced in July 2019 as voluntary measures prompting anger from U.S. President Donald Trump. A month later, the Justice Department opened an antitrust probe into the agreements. The government ended the investigation without action. The Trump administration in March finalized a rollback of U.S. vehicle emissions standards to require 1.5% annual increases in efficiency through 2026. That is far weaker than the 5% annual increases in the discarded rules adopted under President Barack Obama. The 50-page California agreements, which extend through 2026, are less onerous than the standards finalized by the Obama administration but tougher than the Trump administration standards. The automakers have also agreed to electric vehicle commitments. Volvo Cars, owned by China's Geely Holdings, said in March it planned to join the automakers agreeing to the California requirements. It has also finalized its agreement. The settlement agreements say California and automakers agreed to resolve "potential legal disputes concerning the authority of CARB" and other states that have adopted California's standards. In May, a group of 23 U.S. states led by California and some major cities, challenged the Trump vehicle emissions rule. Other major automakers like General Motors Co, Fiat Chrysler Automobiles NV and Toyota Motor Corp did not join the California agreement. Those companies also sided with the Trump administration in a separate lawsuit over whether the federal government can strip California of the right to set zero emission vehicle requirements. Ford said the "final agreement will reduce emissions in our vehicles at a more stringent rate, support and incentivize the production of electrified products, and create regulatory certainty." BMW said "by setting these long-term, predictable, and achievable standards, we have the regulatory certainty that is necessary for long-term planning that will not only reduce greenhouse gas emissions but ultimately benefit consumers as well." 

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

GM readying aluminum-body fullsize pickups

Ford's extensive use of aluminum in its 2015 F-150 is a big deal. A really big deal. Big enough, in fact, that General Motors is reportedly changing its fullsize pickup strategy. According to The Wall Street Journal, The General has locked in partnerships with Alcoa Inc. and Novelis Inc. - companies that will supply aluminum for the next-generation Chevrolet Silverado and GMC Sierra trucks.
"Ford's introduction of the 2015 F-150 pickup truck was a game changer, and it's the first, not the last, conversion of this type," Novelis spokesperson Charles Belbin told the Journal. The switch to aluminum has allowed Ford to shave roughly 700 pounds off its fullsize truck's curb weight. And while official mileage ratings have not been announced, the weight loss should go a long way for improving efficiency, especially when combined other efficiency-minded improvements including better aerodynamics and new, turbocharged V6 engines.
Of course, aluminum-bodied cars are nothing new. But extensive use of aluminum in a major, best-selling product like the Ford F-150 is expected to kick off widespread use of this weight-saving material as availability rises and cost decreases. The WSJ reports that GM had originally explored the idea of moving to aluminum pickups back in 2008, but abandoned the idea due to cost concerns amid economic woes.