2007 Ford Mustang Gt Aux Jack Staggered Tires Heated Seats Power Seats on 2040-cars
Carrollton, Texas, United States
Body Type:Coupe
Vehicle Title:Clear
Engine:4.6L 281Cu. In. V8 GAS SOHC Naturally Aspirated
Fuel Type:GAS
For Sale By:Dealer
Number of Cylinders: 8
Make: Ford
Model: Mustang
Trim: GT Coupe 2-Door
Drive Type: RWD
Mileage: 41,781
Disability Equipped: No
Sub Model: GT Deluxe
Doors: 2
Exterior Color: Black
Number of Doors: 2
Interior Color: Black
Drivetrain: Rear Wheel Drive
Ford Mustang for Sale
2004 ford mustang mach 1 5speed leather shaker hood 70k texas direct auto(US $14,980.00)
2010 roush stage 3 mustang
2003 ford mustang gt 100th anniversary centennial edition convertible
Mustang fox body 1993(US $3,000.00)
1988 ford mustang gt nice and clean, nice paint done right, new wheels and more!
One of one very early ss shelby super snake bob tasca carroll signed convertible
Auto Services in Texas
Zepco ★★★★★
Z Max Auto ★★★★★
Young`s Trailer Sales ★★★★★
Woodys Auto Repair ★★★★★
Window Magic ★★★★★
Wichita Alignment & Brake ★★★★★
Auto blog
A cool boost to turbocharger performance
Fri, Jul 17 2015Since the advent of the forced-induction engine, we have been looking for ways to get every drop of performance we can. There are many approaches to getting additional power using better intercooling, water injection, or even adding nitrous oxide. One take on a short instant burst of power is being researched by Mahle and involves providing supercooled air to an engine, which allows it to burn a leaner fuel mixture and produce more power. The supercooling idea is not new and was examined by Ford in 1993 on the Mustang Mach III concept car, then brought up again in 2003 with the SVT F-150 Lightning concept. Ford called its system the SuperCooler; it was designed to work with any turbocharged or supercharged engine equipped with a water-to-air intercooler. The system on the Lightning concept used a small tank of antifreeze that was hooked up to the truck air conditioning compressor. The air conditioning compressor cooled the antifreeze down to about 30 degrees. The other side of the tank was hooked up to the air-to-water intercooler, which usually had a temperature over 100 degrees. Once the antifreeze was circulated from the tank into the intercooler, it would lower the intercooler temperature and provide for a cooler, denser air charge into the engine; the result was around 50 extra horsepower for a burst of about 30 seconds to a minute, depending on the size of the tank. The system for the Lightning was to be offered as a $750 option and would have been targeted towards drag racers and the like, as it could be used for a run down the drag strip and then re-cooled by the time the truck was back in line. The system was fairly non-intrusive – it only weighed about 25 pounds and did not require a new compressor or intercooler. But as with many concepts, it was ultimately scrapped. The technology was always stuck in the back of my mind, but with larger and more powerful engines being produced it could not find its place. With the advent of new fuel economy standards, we have seen small-displacement turbocharged engines pop up and they seem like the perfect candidate for this type of technology. Ford's EcoBoost 1.0-liter three-cylinder turbocharged engine, as used in the Fiesta and Focus, is one such candidate for this technology. It would add a negligent amount of weight but could provide a boost of 10 to 20 horsepower when needed, like merging onto the highway or catching up to traffic.
Toyota fears supplier pressure in Australia with GM pull out
Wed, 11 Dec 2013With Ford and General Motors both announcing an end to production in Australia, the country's auto industry is in a bad way. With the exit of two big players, there's increased concern that a third Australian manufacturer, Toyota, will be forced out, as well.
"We are saddened to learn of GM Holden's decision. This will place unprecedented pressure on the local supplier network and our ability to build cars in Australia," Toyota Australia said in a statement. The GM closure of Holden production will be the direct end to 2,900 jobs, but will also force a dramatic reduction in the size of the country's supplier network, as there will simply be fewer cars to build.
In the same statement, Toyota Australia said it would work with suppliers and local government to figure out whether continuing production Down Under was even feasible. According to Automotive News, a representative for the Australian Manufacturing Workers' Union told reporters it was "highly likely" that Toyota would also close up shop within the next few years.
Drive Ford's new Mustang in Need For Speed Rivals
Mon, 16 Dec 2013If waiting for the all-new 2015 Ford Mustang to hit dealerships is just too tall of an order, you'll be happy to hear that there is now an alternative means of getting behind the wheel of America's favorite pony car. The Mustang is making its video game debut in Need For Speed Rivals.
"We worked closely with the development team at EA to provide them with engineering data for the new Mustang, several months before we showed it to the rest of the world," said Ford product licensing manager Mark Bentley. "Computer design models enabled the game developers to create an accurate representation of the new Mustang before it goes on sale."
Players will have access to five unique designs for the Mustang, allowing a degree of individuality beyond solid colors and decals. According to Digital Marketing Manager Andrea Zuehlk of Ford, those designs are drawn from the four most popular designs on the Mustang Customizer, an online, mobile and tablet app that allows the public to design their own custom Mustang. A fifth design, penned by drift racer Vaughn Gittin, Jr., is also available.
