Wheeled Coach Ambulance 1 Owner Clean 4x4 on 2040-cars

Auto blog

Ford recalls 90,736 vehicles due to engine valve issue

Ford will recall 90,736 vehicles as engine intake valves in the vehicles may break while driving, the National Highway Traffic Safety Administration (NHTSA) said on Saturday. The recall impacts certain 2021-2022 Bronco, F-150, Edge, Explorer, Lincoln Nautilus, and Lincoln Aviator vehicles equipped with either a 2.7L or 3.0L Nano EcoBoost engine, the NHTSA said. According to documents posted by NHTSA and sourced from the automaker, "The engine intake valves may break while driving, which can result in engine failure and a loss of drive power." Following an investigation that started in January, 2022, Ford found 22 instances where "the engine intake valves fractured and fell into the combustion chamber of the engine causing catastrophic engine damage." The automaker's analysis continues: "Ford identified that the potential root cause of the failures was engine intake valve failure due to valves that exceeded the designed specification for hardness, were brittle, and more likely to fracture. Ford determined that this was due to the supplier’s grinding processes and the sensitivity of the intake valve material to grinding processes that were not within control specifications. The intake valve material was changed for vehicles produced after October 31, 2021." Fixing the problem will require replacement of the entire engine. "Dealers will inspect each vehicle to determine its cumulative number of engine cycles. For vehicles that do not meet the engine cycle threshold, dealers will accumulate high revolutions per minute (rpm) engine cycles per a service procedure. Engines will be replaced on vehicles that do not pass the engine cycle accumulation," Ford says.

Slew of Ford recalls affect more than a million vehicles

Ford is closing out September with the sad task of alerting owners to five different recalls, two of them camera related. The first is a safety compliance recall affecting 620,246 units of 12 models from the 2020 model year: Edge, Escape, Expedition, Explorer, F-150 and Super Duty, Mustang, Ranger, and Transit, plus the Lincoln Corsair, MKX, and Nautilus. On these vehicles, the circuit board in the rearview camera suffers from insufficient electrical conductivity. The issue can cause the resulting image to not appear or to be distorted, which can lead to an accident while reversing. Ford will begin notifying owners as of November 7 to get their vehicles to dealers for replacement of the rearview camera. The internal Ford reference for this recall is 20C19. The second camera-related issue affects the 2020 and 2021 Ford Explorer, Lincoln Corsair and Lincoln Aviator with the 360-degree camera. Technically, if you own a 2021 Explorer that only has a rearview camera and not a 360-degree camera, neither the above recall nor this one apply to you, but it's probably better safe than sorry here. There are 354,330 crossovers covered by this action. A video output issue could cause the displayed image to cut out, increasing the chances of a reversing accident. Ford will notify dealers starting October 7, the fix being to have a dealer update the Image Processing Module software. The NHTSA campaign number for this recall is 21V735, Ford’s internal reference number is 21S44.  The F-250 and F-350 Super Duty are in for another recalls thanks to potentially improper welds on the front axle's wheel end yoke. A bad weld could alter steering performance, getting the truck to pull left or right, or change the sensitivity of the steering. There are 9,628 affected trucks in the U.S. and 961 in Canada. Dealers will replace the axle assembly if any bad welds are found. Ford's reference number for this is 20S56. The fourth recall affects 38,005 Mustangs in the U.S. and another 2,873 Mustangs in Canada and Mexico from the 2020 model year. In this instance, the brake pedal bracket might fracture during sudden stopping, which can decrease brake pressure and increase the chances of an accident. Ford's internal reference for this recall is 20S52, the fix being to have a dealer replace the brake pedal bracket assembly. Finally, 126,033 units of the 2011 to 2013 Explorer are being recalled over a potential suspension issue.

Ford debuts Fusion NASCAR racer that edges closer to stock [w/video]

The sixth-generation NASCAR Sprint Cup racecar, which will make its competition debut at the 2013 Daytona 500 this weekend, marks the closest thing to a "stock car" that the sport has seen in more than 20 years. No longer using just stickers to distinguish the different brands, the image above shows the lengths NASCAR and automakers went in order to create a racecar design that more closely resembles the individual cars they represent.
Ford, one of the more open and vocal OEMs regarding the Gen6 car's development, is giving us a closer look at its racing version of the Fusion with a pretty revealing side-by-side comparison with last years' racer (click above for an expanded view). Aside from the more realistic front end and production-like body lines, the overall shape, dimensions and proportions have also been designed to give the racecar a more stock appearance. Most of the new racer was designed by the Ford Design Center, which the automaker says was the first time it has been so involved in the design process since the 1960s. Of course, one area the Sprint Cup Fusion really differs from the production Fusion is its Ford Racing 5.8-liter V8 producing around 850 hp. Can you say Fusion SVT?
Scroll down for a quick video from Ford Racing showing a production Fusion morph into a Cup car.