2001 Ford F350 7.3 Diesel 4x4 Banks,new Michelins, Super Clean And Ready To Go! on 2040-cars

Auto blog

Ford issues six recalls covering 101,000 vehicles for multiple issues

Ford is announcing six separate recalls for a variety of issues affecting a dozen models and a total of 100,610 vehicles in North America. However, according to Ford spokesperson Kelli Felker, "None of them have caused accidents or injuries." Half of them cover fewer than 1,000 cars.
The largest recall covers 92,022 North American examples (about 83,250 in the US) of some models of the Ford Taurus, Lincoln MKS, Ford Interceptor, Flex and Lincoln MKT from the 2013 and 2014 model years; the 2012-2014 Edge and the 2014 Lincoln MKX. All of them have a potential issue with the halfshaft on the right side that might not be fully seated and could move outward over time. If it shifts too far, the models may no longer be able to drive, and the condition could also allow the vehicles to roll away, even when in Park. Dealers will inspect the shaft to make sure it's seated and will replace the part if necessary.
The next-largest recall covers 5,264 North American examples (4,867 in the US) of the Ford F59 Commercial Stripped Chassis from the 2011-2014 model years. It's possible that an electrical junction box can corrode in areas with salty roads and short circuit. The problem could potentially cause a fire. Dealers will replace the box with an improved design.

BMW V8-powered Ford Model A is the definition of Hot Rod

Today, hotrodding has a pretty staid definition. Take one classic American car, add one classic American V8, sprinkle with tire smoke and you pretty much have every hot rod to roll out of a shop in the last 40 years. Mike Borroughs knows it wasn't always this way. Once upon a time, getting your bucket to go faster meant grabbing whatever parts were lazing about the yard, bolting them together with a bit of ingenuity and laughing your way down the quarter mile. It's in that spirit that Burroughs built his 1928 Ford Model A.
Rather than turn to the tired flathead or the common Chevrolet small block, Burroughs plucked a 4.0-liter V8 from a 1995 BMW 7 Series. With 300 horsepower and 300 pound-feet of torque, the engine has no trouble shuffling the old A around town. He had to build a custom chassis to get everything to cooperate, but the result is a 1,500-pound heathen that looks built to harass dry lake beds. You can check it out in the video below. Be warned, the soundtrack by Hanni el Khatib may not be safe for work - awesomeness of this caliber rarely is.

All eyes on Detroit as automakers prepare for slow, careful reopening of plants

DETROIT — The U.S. factories that make Fords, Chevys and Jeeps are coming back to life this week as workers install new safety equipment and wake up machines ahead of the high-stakes restart the Detroit automakers plan to launch on Monday. Ford, General Motors and Fiat Chrysler Automobiles all plan to reopen North American factories on May 18. The reopening of the U.S. auto sector will be a closely watched test of whether workers across a range of industries can return to factories in large numbers without a resurgence of COVID-19 infections. How well the automakers do will be significant for the U.S. economy, as nearly 1 million workers are employed in the sector. Executives at Ford and GM said separately this week the companies have not recorded any cases of COVID-19 transmission in plants outside the United States since adopting new safety protocols. Those procedures include mandatory face masks, separation of workers on assembly lines, frequent cleaning of work areas and requirements that workers pass through temperature monitors and report any symptoms before entering a plant. The Detroit Three have taken unprecedented steps to share information about coronavirus safety practices and develop a common set of workplace standards for their restarts, working with the United Auto Workers union, executives said. "We thought it was critical that we did it together," Ford manufacturing and labor chief Gary Johnson told Reuters. "We've never done this as an industry." The Detroit automakers will restart U.S. plants without regular testing of workers, because they do not have access to sufficient testing capacity, executives and UAW officials said. They will test workers who report COVID-19 symptoms or have fevers discovered by temperature scanners installed at factory entrances. "We have to continue to push for this testing," United Auto Workers union Vice President Cindy Estrada told Reuters on Wednesday. "Unless we have testing weekly to keep sick people out of the plant there is always a risk." Adopting new safety practices is just part of the work the companies must do to reopen after an extraordinary shutdown that has lasted two months.   Wave zero At Ford, workers going in to ready factories are part of what Chief Operating Officer Jim Farley calls "wave zero." The work of wave zero employees "is really important for success of the startup," he said in an interview.