2005 Extended Cab Long Box Tint Tow Hitch Running Board Lifted Trailer Brake on 2040-cars

Auto blog

Ford builds Lightweight Concept with Fusion shell [w/video]

It's a fairly well known fact that removing weight from a car is essentially a panacea for many of the modern automobiles problems. Does it handle like crap? Remove weight. Underpowered? Don't add power; trim the fat. Need to improve fuel economy? It's diet time.
Actually executing a major weight reduction program, though, much like with human beings, is no easy task. Unlike you or I, where motivation is the issue, the prohibitive measure in trimming a car's waistline is money. Lightweight materials are expensive, with carbon fiber and carbon-fiber reinforced plastic still primarily in the domain of higher end vehicles. Even aluminum construction, pioneered on a mass-produced level by Audi and Jaguar, is only now starting to make its way into the mainstream, thanks to the upcoming Ford F-150.
With this concept, though, Ford is attempting to show that a mass-produced, lightweight vehicle isn't too far off. This is the Lightweight Concept, and while it may look like a Fusion, it weighs as much as a Fiesta. For reference, the lightest Fusion available to the public is the 3,323-pound, 2.5-liter model with a manual transmission. A manually equipped, 1.6-liter Fiesta, meanwhile, is just 2,537 pounds.

At meeting with automakers, Trump launches new attack on NAFTA

WASHINGTON — Ten American and foreign automakers went to the White House on Friday to push for a weakening of U.S. fuel efficiency standards through 2025, while President Donald Trump used the occasion to launch a fresh attack on the North American Free Trade Agreement that has benefited the companies. A draft proposal circulated by the U.S. Transportation Department would freeze fuel efficiency requirements at 2020 levels through 2026, rather than allowing them to increase as previously planned. Trump's administration is expected to formally unveil the proposal later this month or in June. "We're working on CAFE standards, environmental controls," Trump told reporters at the top of the meeting, referring to the Corporate Average Fuel Economy standards for cars and light trucks in the United States. Trump said he wants automakers to build more vehicles in the United States and export more vehicles. But much of the hour-long meeting focused on NAFTA. Trump blasted the pact involving the United States, Canada and Mexico as "terrible" and noted that negotiations to make changes sought by his administration were ongoing. "NAFTA has been a horrible, horrible disaster for this country and we'll see if we can make it reasonable," Trump said. Automakers have called NAFTA a success, allowing them to integrate production throughout North America and make production competitive with Asia and Europe, and have noted the increase in auto production over the past two decades with the deal in place. They have warned that changing NAFTA too much could prompt some companies to move production out of the United States. The chief executives of General Motors Co, Ford Motor Co, Fiat Chrysler, along with senior U.S. executives from Toyota Motor Corp, Volkswagen AG, Hyundai Motor Co, Nissan Motor Co, Honda Motor Co , BMW AG and Daimler AG met with Trump, as did the chief executives of two auto trade groups. Major automakers reiterated this week they do not support freezing fuel efficiency requirements but said they want new flexibility and rule changes to address lower gasoline prices and the shift in U.S. consumer preferences to bigger, less fuel-efficient vehicles.

Project Ugly Horse: Part VII

Devils, Details and Weight Reduction
There are many things I could call this exercise. A party is not one of them.
I've spent three days crammed in the axle well of this 1989 Mustang with nothing to keep me company beyond a trouble light, a DeWalt drill on the very last of its legs and billion razor sharp, red hot slivers of metal with an affinity for my most sensitive of regions. My joints are raw from crawling around on the concrete. I'm half deaf from the shriek of the spot weld cutter and the boom of the cold chisel and hammer.