1996 Ford F-250 Xlt 7.3l Turbo Diesel 4x4 on 2040-cars

Auto blog

Watch Tanner Foust hustle the Fiesta ST 'round the 'Ring

The last time we saw Tanner Foust at the Nürburgring he was sloshing an SVT Raptor from kerb to kerb. Sticking with Ford but swapping keys, this time the drift champion and Top Gear USA host goes to the opposite end of the manufacturer's tuner garage and plucks a Fiesta ST for 'Ring duty.
The 179-horsepower front-wheel-driver acquits itself well by the end of the video. But be warned, Foust doesn't set a 'Ring time and it's shot like a commercial... because that's what it is. Still, you can enjoy all two minutes and 31 seconds of it below.

Ford F-150 pulls semi truck through snow-clogged Chicago streets

Earlier this week, the Midwest was crippled by a massive snowstorm that dumped a foot or more of powder in some areas. The result was, of course, transportation gridlock. It's a fortunate thing for this stranded semi-truck driver, then, that a Ford F-150 EcoBoost stumbled upon him. Despite a tow rating of just over 11,000 pounds, the four-wheel-drive, turbocharged pickup managed to dislodge the big rig from a snow-covered street. Of course, the Ford didn't get the semi moving all on its own – watch the video towards the end and the semi was quite clearly spinning its rear tires. Still, it's an impressive feat that we've little doubt F-Series fans are celebrating. Related video:

NHTSA investigating Ford's solution to May 2014 power steering recall

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.