2002 Ford F-150 Reg Cab 139" Xl on 2040-cars

Auto blog

NHTSA closes Ford F-150 EcoBoost acceleration probe

Typically when we report on the findings of an investigation from the National Highway Traffic Safety Administration, it's because the government body has discovered a safety issue and prescribed a recall. In this case, however, NHTSA has closed an investigation into a reported performance deficit without ever getting to the recall stage.
The issue revolves around the Ford F-150 - specifically those equipped with the 3.5-liter EcoBoost engine - of which some 360,000 were built in the 2011, 2012 and 2013 model years. After receiving an initial 95 complaints, NHTSA opened an investigation last May - almost a year ago - into the reported issue of reduced engine power under hard acceleration. The agency has since received a total of 525 such complaints, and Ford itself reported receiving over 4,000.
Together, NHTSA and Ford determined that the problem resulted from cylinders misfiring, an issue itself stemming from water getting into the charge air cooler (CAC) mated to the turbochargers. In particularly humid or rainy conditions, water was found to get into the CAC, causing some of the cylinders to misfire, which in turn triggered the ECU to disable those cylinders in order to protect the catalytic converter from damage.

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

Report: GM struggling to market turbo technology

In the automotive realm, marketing can sometimes prove just as important as the actual product. Take, for instance, Ford's well regarded EcoBoost technology, which couples turbocharging with direct injection to produce more horsepower and reduce fuel consumption. Would it surprise you to hear that General Motors has had similar technology on the market for over three years?
It's true. GM's first turbocharged, direct injected powerplants hit the market for the 2007 model. The 2.0-liter Ecotec mills put down an impressive 260 horsepower and a matching 260 pound-feet of torque, and they were lauded by the press in the engine bays of the Pontiac Solstice, Saturn Sky, Chevrolet Cobalt SS and Chevrolet HHR SS. But few people outside a core group of enthusiasts actually remember this fact.
Says Uwe Grebe, executive director of GM's global advanced engineering, "We didn't have a badge and say, 'This is the most important thing we will put on all our brochures.'" Ford, however, did just that, and it's EcoBoost engines are right at the tips of all our tongues when we discuss today's most advanced powerplants. So, how does The General fix its mistake?