2000 F-150 Super Cab Lariat 4x4 Step Side Low Reserv A/c Runs And Drives Great on 2040-cars

Auto blog

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

2014 Ford Transit unveiled in Chassis Cab and Cutaway versions

As a leader in commercial vehicles here in the US, we knew Ford wouldn't take too long to show off the chassis cab and cutaway versions of its 2014 Ford Transit van. Set to go on sale this fall, Ford already revealed the full-body version of the Transit, and now it has pulled the cover off exposed-frame models just in time to to compete against the all-new Ram Promaster.
The term "chassis cab" refers to models with a fully enclosed cabin used for box vans or rental trucks, while cutaway models leave the cabin open behind the B-pillars for a pass-through on vehicles such as Class C motorhomes or ambulances. Both will offer three wheelbase options (138, 156 and 178 inches), the choice of single or dually rear axles, and plenty of upfitter-friendly touches including a pre-wired body harness and multiple body mount locations.
The new design will also help make upfitting a little easier since the fuel filler is now built into the cab (just behind the driver's door). Those integrated fuel filler necks will serve to feed either a 3.7-liter V6, a 3.5-liter EcoBoost V6, or a 3.2-liter Power Stroke diesel. Transit chassis cab and cutaways will wear varying Gross vehicle weight ratings from 9,000 pounds to 10,360 pounds depending on spec.

Recharge Wrap-up: Atieva making EV with former Tesla talent, Holland lowers PHEV incentives

A reduction of tax incentives on company cars in Holland is expected to put the brakes on plug-in hybrid sales. Cars are taxed at an average of 25 percent, with plug-in hybrids taxed at just seven or 14 percent, depending on emissions. Taxes on PHEV company cars will increase to 14 and 21 percent. With company car leases making up a third of vehicle sales in 2014, the uptake on PHEVs "will likely go back to regular volumes," according to Volvo's Christiaan Krouwel. It could be a boon for battery electric cars, as their tax rate will remain at four percent for company cars. Read more at Automotive News Europe. Ford is testing cylinder deactivation in its 1.0-liter EcoBoost engine. On-road prototype testing has shown improvements in fuel economy of as much as six percent. Ford engineers developed a system using a new dual mass flywheel, pendulum absorber, and tuned clutch disc to allow cylinder deactivation under a wider range of speed and engine loads with less NVH. "The highest priority in the development of new combustion engines for automotive applications is the ongoing reduction of fuel consumption," says Ford's Andreas Schamel, presenting Ford's findings to the Vienna Motor Symposium. Read more at Green Car Congress or in the press release from Ford. Atieva is building an EV with the help of numerous former Tesla employees. The Silicon Valley-based startup was founded in 2007 by a former Tesla vice president, and its roster includes 12 other former Tesla employees. Already well funded, Atieva is now looking to fill its ranks with more talent, with 32 engineering positions, two recruiter positions and other job openings posted at its website. As for the EV it is working on, Atieva says it is "redefining what a car can be, by building an iconic new vehicle from the ground up." Read more at Charged EVs. Testing shows that Joule ethanol, made from recycled CO2, meets standards for use in the US and Europe. In partnership with Audi, Joule has been working toward making its recycled CO2 fuels ready for commercialization. "We are pleased to achieve another critical step towards our planned near-term delivery of fuel-grade ethanol from recycled CO2," says Joule President and CEO Serge Tchuruk. "Using waste CO2 as a feedstock, our technology has the two-fold advantage of reducing greenhouse gas emissions and producing cost-competitive, drop-in fuels." Joule will use these test results to get government approval for the use of its ethanol in highway fuel.