Awesome 1970 Ford F100 Top-of The Line Ranger Xlt Package Pickup!! on 2040-cars

Auto blog

At meeting with automakers, Trump launches new attack on NAFTA

WASHINGTON — Ten American and foreign automakers went to the White House on Friday to push for a weakening of U.S. fuel efficiency standards through 2025, while President Donald Trump used the occasion to launch a fresh attack on the North American Free Trade Agreement that has benefited the companies. A draft proposal circulated by the U.S. Transportation Department would freeze fuel efficiency requirements at 2020 levels through 2026, rather than allowing them to increase as previously planned. Trump's administration is expected to formally unveil the proposal later this month or in June. "We're working on CAFE standards, environmental controls," Trump told reporters at the top of the meeting, referring to the Corporate Average Fuel Economy standards for cars and light trucks in the United States. Trump said he wants automakers to build more vehicles in the United States and export more vehicles. But much of the hour-long meeting focused on NAFTA. Trump blasted the pact involving the United States, Canada and Mexico as "terrible" and noted that negotiations to make changes sought by his administration were ongoing. "NAFTA has been a horrible, horrible disaster for this country and we'll see if we can make it reasonable," Trump said. Automakers have called NAFTA a success, allowing them to integrate production throughout North America and make production competitive with Asia and Europe, and have noted the increase in auto production over the past two decades with the deal in place. They have warned that changing NAFTA too much could prompt some companies to move production out of the United States. The chief executives of General Motors Co, Ford Motor Co, Fiat Chrysler, along with senior U.S. executives from Toyota Motor Corp, Volkswagen AG, Hyundai Motor Co, Nissan Motor Co, Honda Motor Co , BMW AG and Daimler AG met with Trump, as did the chief executives of two auto trade groups. Major automakers reiterated this week they do not support freezing fuel efficiency requirements but said they want new flexibility and rule changes to address lower gasoline prices and the shift in U.S. consumer preferences to bigger, less fuel-efficient vehicles.

A cool boost to turbocharger performance

Since the advent of the forced-induction engine, we have been looking for ways to get every drop of performance we can. There are many approaches to getting additional power using better intercooling, water injection, or even adding nitrous oxide. One take on a short instant burst of power is being researched by Mahle and involves providing supercooled air to an engine, which allows it to burn a leaner fuel mixture and produce more power. The supercooling idea is not new and was examined by Ford in 1993 on the Mustang Mach III concept car, then brought up again in 2003 with the SVT F-150 Lightning concept. Ford called its system the SuperCooler; it was designed to work with any turbocharged or supercharged engine equipped with a water-to-air intercooler. The system on the Lightning concept used a small tank of antifreeze that was hooked up to the truck air conditioning compressor. The air conditioning compressor cooled the antifreeze down to about 30 degrees. The other side of the tank was hooked up to the air-to-water intercooler, which usually had a temperature over 100 degrees. Once the antifreeze was circulated from the tank into the intercooler, it would lower the intercooler temperature and provide for a cooler, denser air charge into the engine; the result was around 50 extra horsepower for a burst of about 30 seconds to a minute, depending on the size of the tank. The system for the Lightning was to be offered as a $750 option and would have been targeted towards drag racers and the like, as it could be used for a run down the drag strip and then re-cooled by the time the truck was back in line. The system was fairly non-intrusive – it only weighed about 25 pounds and did not require a new compressor or intercooler. But as with many concepts, it was ultimately scrapped. The technology was always stuck in the back of my mind, but with larger and more powerful engines being produced it could not find its place. With the advent of new fuel economy standards, we have seen small-displacement turbocharged engines pop up and they seem like the perfect candidate for this type of technology. Ford's EcoBoost 1.0-liter three-cylinder turbocharged engine, as used in the Fiesta and Focus, is one such candidate for this technology. It would add a negligent amount of weight but could provide a boost of 10 to 20 horsepower when needed, like merging onto the highway or catching up to traffic.

Ford EcoBoost V6 hits the dyno before hitting the track

Ford Racing just unveiled the Riley Daytona Prototype that will make its racing in the United SportsCar Racing Championship Rolex 24 at Daytona in January, and now it has released a video showing development of twin-turbo 3.5-liter EcoBoost V6 that powers the car. Using the same block and heads that can be found on a production Ford Taurus SHO, this new racecar benefits from the collaboration between Ford Racing and Ford powertrain engineers.
While we still don't know what kind of power this engine is putting out, it has definitely gotten a workout at Ford's 17G dyno. This area deep within Ford allows the automaker's racing program to work hand-in-hand with production engine programs, which can be a benefit to racing operations and production cars alike. Scroll down to hear a few people from Ford talk about the crosspollination between its racing and engine teams and watch the EcoBoost get red hot on the dyno.