1955 Ford F100 Pick Up V8 3 Speed 9" Power Steering Super Solid Must See on 2040-cars

Auto blog

Ford opens the doors on its Swedish rally skunkworks

It's always amazing to see how different kinds of racecars are made. Formula One racers are often constructed in modern architectural marvels that hint at some of the cutting-edge technology going into the racing. Conversely, rallying is all about sliding around on a varied course as fast as possible, but it often leaves a vehicle caked in mud. So it makes some sense Olsbergs MSE, or simply (OMSE) rally car shop in Nynashamn, Sweden, shows technological sophistication in a more down-to-earth setting. It builds Ford Fiesta ST racers for Global Rallycross there, and this new video gives viewers a tour through the work.
Former rally driver Andreas Eriksson runs OMSE. These days instead of racing, he and the company's 46 employees are building Ford racers from scratch. A ton of work goes into constructing each one, and according to Eriksson, it takes 400 hours to complete each body. At times, things are so busy that some of the technicians live in the shop in apartments that are on premises. There's even a restaurant to keep them fed. Sadly the dyno room is empty during this visit, though.
By the time OMSE is done, a rallycross car might resemble a Fiesta ST on the outside, but as you see in the video, it's a completely different beast underneath. Check out the work it takes to build one of them, and scroll down to read more about it in the official release.

Reflecting on the Ford GT on its 10-year anniversary

Ten years ago, during the bright-eyed enthusiasm of the early 2000s and before the collective automotive industry did its best Titanic impression, we had the Ford GT. An everyman's supercar like there'd never been (remember, this was before 638-horsepower Corvettes were a thing), the GT arrived with a supercharged, 5.4-liter V8 that produced 550 horsepower and graced this retro-styled rocket with an easy, sub-four-second sprint to 60 miles per hour.
Equal to the GT's performance were its looks. Inspired by the GT40 racers that dominated Le Mans and bested Ferrari in the 1960s, the sleek, low, almost-reptilian look of the GT was the absolute pinnacle of the retro styling that so defined the early 2000s.
Crank and Piston put together a video celebrating the ten-year-old GT, arguing that Ford is a bit too busy with the next-gen Mustang, which turns 50 next week, to do it themselves. In the short clip, there is gratuitous engine noise and supercharger whine, not to mention scenes of the white-on-red GT prowling the deserts and streets of Dubai. It's a bit short, but very nicely shot. Scroll down, have a look and be sure to turn up those speakers before getting started.

NHTSA investigating Ford's solution to May 2014 power steering recall

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.