Leather Back Up Camera Factory Warranty Cruise Control Off Lease Only on 2040-cars

Auto blog

Toyota fears supplier pressure in Australia with GM pull out

With Ford and General Motors both announcing an end to production in Australia, the country's auto industry is in a bad way. With the exit of two big players, there's increased concern that a third Australian manufacturer, Toyota, will be forced out, as well.
"We are saddened to learn of GM Holden's decision. This will place unprecedented pressure on the local supplier network and our ability to build cars in Australia," Toyota Australia said in a statement. The GM closure of Holden production will be the direct end to 2,900 jobs, but will also force a dramatic reduction in the size of the country's supplier network, as there will simply be fewer cars to build.
In the same statement, Toyota Australia said it would work with suppliers and local government to figure out whether continuing production Down Under was even feasible. According to Automotive News, a representative for the Australian Manufacturing Workers' Union told reporters it was "highly likely" that Toyota would also close up shop within the next few years.

Question of the Day: Worst year of the Malaise Era?

The Malaise Era for cars in the United States spanned the 1973 through 1983 model years, and featured such abominations as a Corvette with just 205 horsepower (from the optional engine!) and MGBs with suspensions jacked way up to meet new headlight-height requirements. There were many low points throughout this gloomy period, of course. The horrifyingly low power and fuel-economy numbers for big V8s during the middle years of the Malaise Era make a strong case for 1974 or 1975— the years of Nixon's resignation and the Fall of Saigon, respectively— as the most Malaisey years. But then the GM-pummeling debacles of the Chevy Citation and Cadillac Cimarron could make an early-1980s year the low point. 1979, the year of the ignominious Chrysler bailout? You choose! Related Video:

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.