2008 Ford E350,v8 14-passenger Van on 2040-cars

Auto blog

NHTSA and Ford investigating steering issues in Crown Vic, Grand Marquis and Marauder

There may be more steering woes for the Ford Crown Victoria. The National Highway Traffic Safety Administration has opened a preliminary evaluation into the Crown Vic and Mercury Grand Marquis from the 2004 to 2007 model years and the Mercury Marauder for the 2004 and 2005 model years because the steering shaft can jam. The issue could potentially affect an estimated 500,000 vehicles.
According to the regulator, there is a possibility that the driver's side heat shield for the exhaust manifold can rust, dislodge, and then wedge into the steering shaft. If this occurs, it leads to a situation where the driver can no longer control the car.
NHTSA has received five complaints of this happening, including one alleged case with an injury. In that situation, the car was driving onto the highway, lost control and rolled over. One occupant was hurt in the accident.

Ford GT dominates Le Mans qualifying, gets slapped with performance adjustment

Fifty years after Bruce McLaren and Chris Amon drove the Ford GT40 to victory at the 24 Hours of Le Mans, Ford is poised for a historic return to the Circuit de la Sarthe. The new Ford GT took the top two qualifying positions in the LMGTE Pro class, and four of the top five. Ferrari's 488 filled in the rest of the spots in the top seven, the first two from AF Corse. In other words, we're primed for a reboot of the classic Ford-Ferrari feud at this year's race. Or not, as the ACO, which organizes the 24 Hours of Le Mans, announced sweeping pre-race Balance of Performance (BOP) adjustments this morning that make this year's GT class anybody's race. In LMP1, last year's overall winner Porsche locked up the top two spots with the 919 Hybrid and will lead the entire field at race start. Toyota's two-car factory effort followed with qualifying times 1.004 and 2.170 seconds behind the pole lap. Audi rounds out the manufacturer-backed LMP1 class in fifth and sixth. Full qualifying results can be found here. The storyline for the GT cars is perfect - some say too perfect. Ford's class-leading times came after BOP adjustment to the Corvette Racing C7.R before qualifying. BOP is intended to level the playing field in the class by adjusting power, ballast, and fuel capacity. (Check out this explainer video for more, or even just if you love French accents.) But the process is riddled with unknowns and ripe for accusations of sandbagging. That is, if the Ford cars were intentionally slow in practice they could hope for BOP adjustment to improve their race chances. On the Corvette side, last year's GTE Pro winner went from the top of the field to the bottom, barely improving from practice to qualifying. If you think Le Mans is as rigged at the NBA Playoffs, well, it's not that simple. Because if Ford and Ferrari held back until qualifying - the eighth-place Porsche 911 RSR is three-and-a-half seconds off the class pole time - it was a pretty dumb strategy. This morning, the ACO tried to put things back in order by limiting the boost in the Ford GT's twin-turbo V6 and adding 11 pounds of ballast. Ferrari was also given extra weight but allowed more fuel capacity. The Corvette and Aston Martin teams were both given breaks on their air restrictors, which will allow their engines to make more power. Both Ford and Porsche also received extra fuel capacity.

Ford running short of F-150 frames

Like most any automaker, Ford is eager to build as many F-150 pickups as it can sell. And considering that the truck has long stood as the top selling vehicle in the United States, that means building (and selling) a lot of them. Further, Ford reports that its factories are finally fully up to speed and ready to build as many F-150s as dealers can sell. Unfortunately another factor is reportedly preventing the new aluminum-bodied pickup from reaching its potential. According to Automotive News and as we've heard before, the Blue Oval automaker has had trouble getting its hands on as many frames as it needs. Though Ford would not confirm the shortage itself, AN cites union sources in reporting that the Metalsa plant in Kentucky, which produces the new F-150's frame for Ford, has been unable to meet the demand for more such frames. "Whenever you have launches, you have issues that you have to deal with in the supply base," is all Ford CFO Bob Shanks would admit. "We're always working closely with suppliers if there's an issue to sort it out. If that were the case, that's what we'd be doing." The reported supply shortage could be why plans for overtime production are reportedly being canceled at both the plants in Kansas City and Dearborn where the F-150s are assembled, despite reaching or nearing full capacity. The shortage could also help explain why, according to AN, sales of the F-Series in the United States fell nearly 10 percent last month, while the rest of the pickup market rose 17 percent. Related Video: