Ford F-100 F100 on 2040-cars

Auto blog

Ford recalls 90,736 vehicles due to engine valve issue

Ford will recall 90,736 vehicles as engine intake valves in the vehicles may break while driving, the National Highway Traffic Safety Administration (NHTSA) said on Saturday. The recall impacts certain 2021-2022 Bronco, F-150, Edge, Explorer, Lincoln Nautilus, and Lincoln Aviator vehicles equipped with either a 2.7L or 3.0L Nano EcoBoost engine, the NHTSA said. According to documents posted by NHTSA and sourced from the automaker, "The engine intake valves may break while driving, which can result in engine failure and a loss of drive power." Following an investigation that started in January, 2022, Ford found 22 instances where "the engine intake valves fractured and fell into the combustion chamber of the engine causing catastrophic engine damage." The automaker's analysis continues: "Ford identified that the potential root cause of the failures was engine intake valve failure due to valves that exceeded the designed specification for hardness, were brittle, and more likely to fracture. Ford determined that this was due to the supplier’s grinding processes and the sensitivity of the intake valve material to grinding processes that were not within control specifications. The intake valve material was changed for vehicles produced after October 31, 2021." Fixing the problem will require replacement of the entire engine. "Dealers will inspect each vehicle to determine its cumulative number of engine cycles. For vehicles that do not meet the engine cycle threshold, dealers will accumulate high revolutions per minute (rpm) engine cycles per a service procedure. Engines will be replaced on vehicles that do not pass the engine cycle accumulation," Ford says.

Thanks for keeping us on our toes, Detroit Auto Show [w/poll]

Here at Autoblog, we love unexpected debuts at auto shows – and judging by our Detroit Auto Show comments and traffic, you do, too. Surprise reveals have been fewer and farther between in recent years with so many ways for vehicles to be teased or leak out, but this week's show has been a revelation. More to the point, it's been a series of revelations, with automakers from around the globe successfully delivering a brace of concept and production surprises. It's made our jobs a lot more exciting and challenging this week, and even though it's actually more work to react and run-and-gun when the sheet is pulled on a surprise reveal than it is to publish an already-written embargoed story, we've had more fun covering this show for you than any domestic show in memory. We hope you've enjoyed the surprises along with us. To that end, borrowing the words of an unnamed automaker PR flack, we'd like to thank the following automakers for enduring "mountain of antacids" and that "creeping sense of paranoia" necessary to keeping ones' wares totally under wraps until the sheets are pulled off the sheetmetal: Buick Avenir concept Chevrolet Bolt concept Ford GT concept Ford Mustang Shelby GT350R Ford F-150 SVT Raptor Hyundai HCD-15 Santa Cruz concept And while we're at it, we'd like to throw in an shout-out to Detroit's substantially revised and revitalized Cobo Center, and in particular, the redone Michelin media center, which is arguably the single best accommodations for writing show stories that we've encountered on the entire international circuit. Well done, everyone. Thank you, and keep the surprises coming. Auto News Detroit Auto Show Buick Chevrolet Ford Hyundai Volvo 2015 Detroit Auto Show

How the Ram Multifunction Tailgate compares to Ford, GMC, Honda

Ram just announced its Multifunction Tailgate — a descriptive if not very creative name. It's an asymmetrical barn-door arrangement, which can both fold down like a conventional tailgate or swing open like a gate. There's a new bed step, but unlike Ford or GM, the step isn't part of the tailgate itself. Rather, it kicks out from under the bumper (as opposed to out from under the driver's side of the rear bumper in its previous incarnation). So let's just focus on the tailgate functionality. A video of the Ram Multifunction Tailgate in action is above. For one, either of the swinging tailgate sections can be opened independently. They open to a full 88 degrees. In conventional flip-down mode, the tailgate works just like a normal one, too, with a 2,000-pound rating. The bottom line is that while it gives a variety of types of access to the load area, it doesn't "do" anything else. It's a $995 option on any Ram 1500. Its closest analogue is the Honda Ridgeline, which works basically the same way, but on that truck the tailgate swings as one piece. And the Honda's load rating isn't as hefty as the Ram's tailgate: 300 pounds. As Honda says, that's sufficient to hold the weight of the part of an ATV hanging out of the bed, or something similar, but it's a lighter-duty unit (and a lighter-duty truck) than the Ram's overall. Let's also get Ford's one-trick tailgate out of the way before comparing to the more analogous, and complicated, GM MultiPro. A bit of trivia: Ford's optional Tailgate Step is actually designed and supplied by Multimatic, better known as the outfit that builds the Ford GT and produces the DSSV spool-valve shocks. This step has been available for years. It pulls out of the top edge of the tailgate when the tailgate is lowered, deploying a single step. A separate handle pulls out from beside the step and flips up, giving a handhold. While it was initially (and infamously) mocked by competitors, with load floor heights as high as they are it's better than toting around a stepstool. It's currently a $375 standalone option. Now we get to the GMC MultiPro tailgate, the most complicated and multi-functioned around. It's essentially a tailgate within a tailgate, with a fold-out stopper that deploys from the inner tailgate. This gives it several functions depending on the position of all the parts. It can still be used like a normal tailgate, dropping down at the push of a button or using the key fob.