1992 1/2 Ford Mustang Limited Edition Feature Car Convertible 5 Spd 5.0 Vibrant on 2040-cars

Auto blog

NHTSA investigating Ford Fiesta for faulty door latches

The National Highway Traffic Safety Administration has opened a preliminary investigation on the 2011-2013 Ford Fiesta because the regulator has received 61 complaints from drivers, including one claim of an injury, about the doors on the subcompacts failing to latch and sometimes even flying open while driving. NHTSA has estimated that the problem could affect as many as 205,000 vehicles.
NHTSA is still gathering further data about the problem, but looking at the complaints so far, both front and rear doors appear to be potentially involved with the alleged failures. Among the reports, there are 12 claiming that the door opened while driving. Several also indicate the "Door Ajar" warning illuminating during this problem. The one purported injury happened when someone attempted to shut the door, and it bounced back.
Ford spokesperson Kelli Felker told Autoblog via email, "We are cooperating with NHTSA on this investigation, as we always do." Scroll down to read the report from NHTSA.

Next-gen Ford Cobra Jet development underway, but will it be a Mustang?

Ford might be stepping away from the NHRA, but it isn't abandoning drag racing altogether. Hot Rod says that Ford confirmed a next-gen Cobra Jet factory drag racer is in the works, but the report also speculates that a new Cobra Jet could switch away from the Mustang nameplate.
Even though talk of a new Cobra Jet coincides with the all-new 2015 Mustang, the lack of confirmation for the dragster's platform leaves Hot Rod to guess that the car might switch to another platform - specifically a front-drive-based, unibody car like the Fusion or Taurus. We'd hate to think of a world with a NASCAR-ized dragster from Ford Racing, but it's also highly unlikely that the Mustang Cobra Jet would step away from its quarter-mile rivals like the Chevy COPO Camaro and Dodge Challenger Drag Pak.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.