1929 Ford Model A on 2040-cars

Auto blog

Ford recalls 600,000 older-model sedans for braking issue

Ford is recalling 600,166 older-model Ford, Lincoln and Mercury vehicles over an issue that could affect braking and increase the risk of a crash. The safety recall covers certain Ford Fusion, Mercury Milan and Lincoln MKZ sedans from the 2006 through 2010 model years that were built at Ford’s Hermosillo Assembly Plant in Mexico between Feb. 22, 2006, and July 15, 2009. Ford says a valve that is normally closed inside the hydraulic control unit may get stuck in the open position or be slow to close, which could make it harder to engage the brakes and increase risk of a crash. Ford says itÂ’s aware of 15 reports of accidents and two injuries possibly related to the issue. Dealers will inspect the hydraulic control unit for signs of the problem and replace it, if necessary. The dealers will pressure-flush the system with brake fluid and replace the reservoir cap with a new one. Ford is also issuing a small recall of 33 of its 2020 F-150 trucks in the U.S. and 51 in Canada over potentially damaged spare tires. It says the bead area on the tires may have been damaged when it was mounted onto the wheel assembly, leaving it vulnerable to corrosion, separation of the bead wire and ultimately a rapid loss of air pressure and detachment from the wheel. Dealers will replace the spare tire. Affected vehicles were built at the Dearborn Truck Plant from Nov. 10-21 of this year.

Lincoln MKC recalled because start button located too close to touchscreen [UPDATE]

UPDATE: Ford spokesperson Kelli Felker responded to our questions and let us know that the fix for the push-button start on the 2015 MKC has the switch moved to the top of the of the column of gear shift buttons instead of the bottom. Owners should be notified about both campaigns "toward the end of February." After massive campaigns from General Motors and to fix Takata airbag inflators, 2014 will undoubtedly go down as The Year Of The Recall. And with little time to spare, Ford is getting in just under the wire to adding two more to its yearly total. The larger of the campaigns is actually one of the most bizarre campaigns we've heard of all year. Lincoln is recalling 13,574 units of its 2015 MKC compact crossover in North America to move the location of the push-button ignition switch on the dashboard. According to the automaker's announcement: "Due to the switch's close proximity to other controls, occupants are inadvertently shutting off the engine while driving." The button is located near the bottom of the touchscreen, which can apparently make it possible to hit by mistake. Back when Autoblog first drove the new MKC in June, we came away very impressed, but noted: "... we're still not completely sold on the aforementioned pushbutton transmission selector ... it still seems somewhat gimmicky and it can't be operated by feel alone, as you might when shifting a traditional console-mounted lever from Park to Drive." According to Lincoln, there have been no reported accidents or injuries stemming from this button misapplication. Of the affected vehicles, there are 11,144 in the US, 2,033 in Canada and 397 in Mexico. To fix the problem, dealers are moving the button to a different location and reprogramming the powertrain control module. According to Automotive News, models built since September already have a different layout. The change was reportedly done to match the rest of the Lincoln lineup. The second recall covers 12,205 units of the 2014 Ford Escape (2015 model year pictured below) and 2015 Lincoln MKC in North America because of a problem with nickel plating on the fuel pump. The issue can cause the pump to seize, which can cause the crossovers not to start or stall while driving. The automaker is not aware of any accidents or injuries related to this fault. Dealers are replacing the fuel deliver module to fix the situation. Of the affected vehicles, there are 9,038 in the US, 3,074 in Canada and 93 in Mexico.

Should reflective paint earn automakers EPA credits?

No matter where you look around the world, governments are cracking down on vehicle emissions and aiming for higher fuel economy standards. Generally, automakers are pushing back against the increased regulation, and in the US, General Motors, Ford, and FCA US are looking for new compromises. The Big Three want to the EPA to grant them retroactive emissions credits for using tech that they claim reduces CO2 but not on the government agency's on-road testing. Among these technologies are things like reflective paint and glass, LED lights, ventilated seats, stop/start, and more efficient air conditioning compressors. Starting with the 2014 model year, the automakers can receive credits for a few grams per mile reductions on models with some of these solutions, according to Automotive News. However, the companies are also petitioning the EPA to make the credits apply to earlier vehicles with them, as well. The emissions advantages for systems like stop/start and less polluting AC refrigerants seem fairly obvious. For reflective paint and glass, the belief is that keeping a vehicle interior cooler should mean a lower need for air conditioning and therefore a decrease in CO2. Margo Oge, the former boss of the EPA's Office of Transportation Air Quality, told Automotive News these credits are part of the plan. "That's the whole point of what we tried to establish," she said. "We wanted companies to invest in and develop these technologies." The EPA wants vehicle emissions at the corporate average equivalent of 54.4 miles per gallon fuel economy by 2025, and so far that seems achievable. It will translate to less than 40 mpg on the EPA sticker. In a report last summer, the industry was about 10 grams per mile of CO2 better than the rules required, and that was solely based on 2012 model year vehicles. In an update for 2013, the companies were up to 12 grams per mile beyond targets. News Source: Automotive News - sub. req.Image Credit: Mark Humphrey / AP Photo Government/Legal Green Ford GM Emissions Fuel Efficiency FCA fca us