2007 Ford Focus on 2040-cars

Auto blog

Ford recalls 1.48 million F-150s for transmission, plus other models

Weeks after recalling more than 800,000 F-Series pickup trucks for a fire risk, Ford has issued another separate recall for approximately 1.48 million 2011-2013 F-150s for a transmission fault. The six-speed automatics could unexpectedly downshift into first gear without warning. Ford and Lincoln tangentially issued much smaller recalls for the Mustang, Continental, Nautilus, and Navigator. According to Ford, some 2011-2013 model year F-150 pickups with six-speed automatic transmissions could "experience an intermittent loss of the transmission output speed sensor signal to the powertrain control module." This could potentially cause the trucks to temporarily downshift, which could be dangerous if it occurs while driving. Of the 1.48 million affected trucks, 1.26 million are in the U.S. while 221,000 are in Canada. Thus far, Ford knows of five reported accidents involving the issue. To remedy the problem, owners can take their trucks to dealers to update the power control module software. Ford also issued recalls for about 4,350 2019 Mustangs, Lincoln Nautiluses, and Lincoln Navigators in the U.S. and Canada due to a possible fault with the instrument clusters. Although there have been no reports of accidents, Ford says the instrument panel clusters assemblies might be blank or not turn out when the vehicle is started. Additionally, Ford issued a third recall for 28,200 2017-2019 Lincoln Continentals in the U.S. and Canada. Ford says silicon contamination might build up inside the door latch motor, causing it to malfunction. As a result, the door latch might not always fully engage, and the doors could possibly open unexpectedly. Despite no reports of accidents, Ford will remove and replace door latch assemblies on all doors for those affected by the defect. If any of these apply to a vehicle you own, contact Ford to discuss whether it is included in any of these recalls and have the vehicle checked out at a Ford dealership.

How Ford switched gears for the all-new F-150

Editor's Note: This story is authored by Julia Halewicz, a senior editor with AOL's Custom Solutions Group. She holds a Masters in Journalism from NYU and has spent her career as an editor of various newspapers, magazines and digital outlets. Last year on the Friday before Labor Day, the 2014 Ford F-150 pickup truck came off the Dearborn assembly line for the last time. After the last seam was welded, the F-150 that had been so beloved by American consumers would begin the transition from traditional steel manufacturing to an aluminum body, and the second phase of Ford's 2007 blueprint for sustainability would begin. Jobs would be created, and Ford would deliver a stronger product to its consumers. It was a moment Ford would call the biggest in the company's 111-year history. Breaking The Mold For some, the change was almost unfathomable. How could a truck be made with aluminum, and why change what clearly was working very well for the company? "We have a saying at Ford that leaders lead," said Doug Scott, the company's truck group marketing manager. "This was an ideal product to make with aluminum-alloy, because lightweighting made so much sense for a truck, because the extent to which you could take weight out of a truck, you could add more value to the customer in terms of more towing, more payload, more durability, more efficiency – so again all this required us to be out in front further out in front that we normally would be to make sure that we would deliver on all those expectations." Ford began the planning process about five years before the first aluminum F-150 would come to market. The company had a lot of questions. What was customer acceptance of aluminum, could they build the truck, and could the truck be repaired out in the field? Finally, Ford needed to determine if there were enough materials available to support the demand for the F-Series. Aluminum vehicles aren't unusual, but had never been built on the scale of the F-150 – approximately one every minute. Ford created two prototypes to determine if the product would meet and exceed consumer expectations. Any change to the vehicle had to be justified in performance, safety and economy. An aluminum truck needed to be safer, lighter, have increased payload, haul more, and have improved fuel efficiency. After driving the prototypes, Ford knew it was ready to move forward. Once the aluminum truck was ready to build, the next challenge was quickly transforming the plant.

Ford F-150, Toyota Tacoma top ASG list of most eco-friendly trucks

No one's going to confuse the massively popular Ford F-150 pickup truck with a green vehicle, but at least it performs well in an environmental sense when compared to its brethren. The Automotive Science Group (ASG) took on the odd (to us, at least) task of measuring which pickup trucks are friendliest to the environment and found that the big seller in the Blue Oval's flagship F-series came up big, while the Toyota Tacoma came up, well, slightly smaller. That's a good thing. Among the 245 light-duty trucks that ASG studied, the 3.7-liter V6-powered F-150 won ASG's award for full-size trucks for both regular and crew cabs. Meanwhile, the 2.7-liter Toyota Tacoma, with its fuel-economy rating of 23 miles per gallon combined, had smallest overall life-cycle carbon footprint and won ASG's two mid-sized categories. Finally, the Chevrolet Silverado won best all-around performance in the full-size extended-cab category. The ASG factored in eco-friendliness, price and social performance (which is measured by, "considering the rights of those charged with vehicle manufacture and assembly") to come up with its findings. Sales of Ford's F-Series trucks rose 8.4 percent last year to 74,592 units and accounted for more than a third of the total 2013 sales of Ford and its Lincoln unit. Check out the ASG's press release below. Truck Buyers Faced With "Eco" Options Galore Which 2014 full-size trucks warrant eco claims? 25 March 2014 [Santa Rosa, CA] – With a myriad of eco-branded trucks hitting the North American marketplace in 2014 – from Ford's EcoBoost and GM's EcoTec3 to Ram's latest addition, the EcoDiesel – the Automotive Science Group (ASG) was prompted to offer an objective, scientifically-based assessment to determine exactly which 2014 trucks actually earn their "eco" badge. According to ASG and the principles of ecological economics, a vehicle's eco-rating must be multi-faceted to include both environmental and economic considerations, and so the Group's proprietary rating platform – the Automotive Performance Index – does just that. Using a unique combination of vehicle data inputs that include conventional specifications as well as social, environmental and economic performance indicators, ASG's vehicle assessments empower consumers to make choices based on one's personal principles and financial requisites.