Diesel New 6.7l 4x4 Engine Block Heater Rapid-heat Supplemental Cab Heater Abs on 2040-cars

Auto blog

2017-19 Ford Super Duty trucks recalled for tailgates that could open

Ford announced two separate recalls today, though neither has resulted in any known injuries. The first recall, which deals with a tailgate malfunction, affects 261,617 examples of 2017-2019 F-250, F-350, and F-450 Super Duty pickups. The second, which anticipates the possibility of a fuel leak, affects 3,893 units of 2020 Explorer and 2020 Lincoln Aviator SUVs with 3.0-liter engines. Ford says tailgates might accidentally open on some 2017-2019 Super Duty trucks because of a short circuit. If the pickups have an electric tailgate latch-release switch on the tailgate handle, water might get into the wiring. If the water hits the right spots, a short circuit could cause the switch to release the tailgate latch. In a worst-case scenario where the tailgate opens while driving, contents of the truck's bed could fall out and create a safety hazard. Dealerships will fix the problem by modifying the tailgate frame wiring harnesses with jumper pigtails and install a new tailgate handle release switch. Of the lot, 231,664 trucks are in the U.S., and 29,953 are in Canada. The Ford recall number is 19S48.  The second recall is much smaller, involving fewer than 4,000 vehicles. In certain 2020 Explorers and Aviators with 3.0-liter engines, Ford says, "The convolute protective sleeve on the liquid fuel line is not long enough, which may allow for potential hard contact with the convolute-protected vapor fuel line. Over time, with vibration and engine roll, hard contact between the two fuel lines could cause the convolute on the vapor fuel line to rub through the plastic liquid fuel line." If that happens, it could be a fire risk and hazardous for drivers and passengers. Only 35 of those SUVs are in Canada, and the rest are in the United States. Dealers will fix the problem by replacing the defective convolute with a full-length piece and tying it down with a strap. The recall reference number for the Aviators and Explorers is 19S49. The recall adds to what has otherwise been a rocky early production phase for the new Explorers and Aviators.

Ford vandalizes the SEMA Show floor with 2014 Transit Connect

The Ford booth here at SEMA is practically a 1970s throwback with all these customized vans sitting front and center. And we're completely fine with that. Take the black and yellow (black and yellow, black and yellow) 2014 Transit Connect from Mobsteel above. It's got a great stance, sits on steel wheels and has a pretty cool paint job and graphics package to boot.
Of course, that's not the only van you can see at the Ford booth. In fact, there are 10 Transit Connect vans on display from Ford here at SEMA, and you can see them all in our live gallery of high-res images above. Then, if you want to know more about each specific model, feel free to scroll down to read all about these vans in the official press release from Ford.

Shelby GT350R offers first mass-produced carbon fiber wheels

In the world of race engineering, reducing total weight is good, but reducing unsprung weight is flippin' fantastic. That's the reason Ford is pushing the envelope in terms of technology for the Shelby GT350R's wheels. Joining the likes of Koenigsegg in the offering, Ford has teamed with Australian outfit Carbon Revolution to produce the CF rollers en masse for the first time. Destined for the hubs of the new Shelby GT350R, the new hoops weigh just 18 pounds each, versus the 33-lbs weight of a similar aluminum wheel. On top of slashing up to 60 pounds in unsprung weight, there's such a reduction in rotational inertia – 40 percent, versus aluminum wheels – that Ford actually has to recalibrate the magnetic ride control system and springs. Thanks to, we're guessing, scenes of crashed Formula One cars disintegrating and spewing shards of carbon fiber all over the track, Ford seems quite keen to do away with the idea that CF is strong, but brittle. The company conducted extensive shock testing, ramming a wheel into a curb at speed. According to the Blue Oval, the lightweight wheel allowed the suspension to respond so quickly that the impact was "greatly diminished," causing the tester to run the experiment again, thinking there'd been a mistake. After recording brake rotor temperatures of 900 degrees Celsius (over 1,650 degrees Fahrenheit, or well past the point that aluminum or magnesium would melt) during testing, Ford and Carbon Revolution actually redesigned the wheels to "a thermal standard more suitable for motorsports," by adding an "incredibly thin, nearly diamond-hard coating that reliably shields the resin from heat." The same process was used to protect engine turbine blades on the Space Shuttle. While the work by Ford and Carbon Revolution should make GT350R customers excited, the work being done here could have serious implications for performance cars in the future. That's the real takeaway here, and is something that should leave fans of all performance vehicles excited.