(no Reserve) Ford F350 7.3l Diesal Truck 14ft Box W/2000lbs Rear Lift Only 47kmi on 2040-cars

Auto blog

2015 Ford F-150 configurator is ready to go to work

Ford is inching towards the on-sale date for the eagerly anticipated, aluminum F-150 pickup. While we're preparing to drive the new truck (expect our take on it sooner rather than later), the best-seller has reached another, albeit more minor, milestone as its online configurator has officially been switched on.
We took to Ford's consumer website to mess about with it and see just how ridiculous of a truck we can build. Among the fun things we discovered were these two nuggets - the most expensive truck we could configure was not the top-end Platinum model, but instead the King Ranch, which rang up at $65,955. The other exciting discovery? The new truck would be available in a questionable shade called Blue Jeans (shown above with the optional contrasting Caribou paint). Yep, Blue Jeans.
You can head over to Ford's consumer page and build your very own aluminum F-150 now. Take a look.

Ford announces four recalls, 1.4M vehicles affected

Ford is taking a bit of the spotlight away from General Motors, announcing a major group of recall campaigns, covering a total of 1.4 million vehicles built between 2006 and 2013.
Let's start with the big one, which covers the Ford Escape, Mercury Mariner and, according to The Detroit News, Ford-built Mazda Tribute CUVs. 915,216 vehicles are covered, all of which were built in model years 2008 to 2011. 736,000 vehicles are in the US, while Canada then Mexico make up the vast majority of the remainder. The problem is due to an issue with the torque sensor in the steering column, which could lead to sudden power steering failure. Manual steering would still be available, though.
"Dealers will perform one of three service fixes, depending upon what diagnostic codes are shown when the vehicle is taken to the dealer," Ford spokeswoman Kelli Felker wrote to Autoblog in an email. "They will either update software for the power steering control module and the instrument cluster module; replace the torque sensor; or replace the steering column, which includes upgraded power steering control module software."

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.