New 2013 Ford Super Duty F-250 4wd Crew Cab Platinum Diesel Msrp $64400 on 2040-cars

Auto blog

Ford recalls 1.48 million F-150s for transmission, plus other models

Weeks after recalling more than 800,000 F-Series pickup trucks for a fire risk, Ford has issued another separate recall for approximately 1.48 million 2011-2013 F-150s for a transmission fault. The six-speed automatics could unexpectedly downshift into first gear without warning. Ford and Lincoln tangentially issued much smaller recalls for the Mustang, Continental, Nautilus, and Navigator. According to Ford, some 2011-2013 model year F-150 pickups with six-speed automatic transmissions could "experience an intermittent loss of the transmission output speed sensor signal to the powertrain control module." This could potentially cause the trucks to temporarily downshift, which could be dangerous if it occurs while driving. Of the 1.48 million affected trucks, 1.26 million are in the U.S. while 221,000 are in Canada. Thus far, Ford knows of five reported accidents involving the issue. To remedy the problem, owners can take their trucks to dealers to update the power control module software. Ford also issued recalls for about 4,350 2019 Mustangs, Lincoln Nautiluses, and Lincoln Navigators in the U.S. and Canada due to a possible fault with the instrument clusters. Although there have been no reports of accidents, Ford says the instrument panel clusters assemblies might be blank or not turn out when the vehicle is started. Additionally, Ford issued a third recall for 28,200 2017-2019 Lincoln Continentals in the U.S. and Canada. Ford says silicon contamination might build up inside the door latch motor, causing it to malfunction. As a result, the door latch might not always fully engage, and the doors could possibly open unexpectedly. Despite no reports of accidents, Ford will remove and replace door latch assemblies on all doors for those affected by the defect. If any of these apply to a vehicle you own, contact Ford to discuss whether it is included in any of these recalls and have the vehicle checked out at a Ford dealership.

Ringbrothers drops more hints about its wild SEMA creations

Ringbrothers isn't finished teasing its SEMA creations. First we got a sliver of rear quarter on a 1969 Chevrolet Camaro that revealed a bundle of carbon fiber and SEMA-obligatory deep-dish wheels. The Wisconsin tuner's now announced its litter of cars headed to the show and a few specs, along with two shadowy drawings. The Camaro, christened with the name Valkyrja and a two-tone paint job, gets stretched in two directions with severe fender flares to widen the body and an extended wheelbase. We're not sure what's happening with the Camaro's snout in the drawing, but under that bulging hood we'll find a 416-cubic-inch LS V8 from Wegner Motorsports. Wegner built the 416-cu-in supercharged LS3 V8 that powered Ringbrothers' 1,000-hp G-Code Camaro in 2016.  The second member of the gang is a 1969 Ford Mustang Mach 1 dubbed Unkl. The exterior begs for attention with a deep blue sea paint job, deep front chin spoiler, bulging hood, yellow brake calipers, and what looks like a racing number inside a roundel on the doors. Unkl gets its motivation from a 520-cu-in Boss V8 built by Kaase Racing Engines, rumored to throw about 800 hp.    Finally, Ringbrothers is bringing its Cadillac Madam V for another Las Vegas go-round after giving the custom coupe some updates. The Madam V is a 1948 Cadillac Series 62 fastback coupe body placed atop an ATS-V chassis, first shown in 2016. The firm didn't elaborate on the changes, so all we can expect for now are the coupe's postwar good looks mixed with new-millennium engineering, and a 3.6-liter twin-turbo V6 with 464 hp under that exceptionally long hood.    For any in attendance at the show, the Valkyrja Camaro debuts at the BASF booth on Tuesday, Nov. 5, 2019 at 9:30 a.m., the Unkl Mustang gets revealed a couple hours later at the Flowmaster/Holley booth, and the Madam V Cadillac will be on display throughout the show at the Ringbrothers booth.

Bill Ford op-ed argues we can't just build and sell more of the same cars

It's hardly a secret that the auto industry is undergoing an enormous, tectonic shift in the way it thinks, builds cars and does business. Between alternative forms of energy, a renewed focus on low curb weights and aerodynamic bodies, the advent of driverless and autonomous cars and the need to reduce the our impact on the environment, it's very likely that the car that's built 10 years down the line will be scarcely recognizable when parked next to the car from 10 years ago.
Few people are as able to explain the industry's many upcoming changes and challenges as clearly as William Clay Ford, Jr., better known as Bill Ford. The 57-year-old currently sits as the executive chairman of the company his great-grandfather, Henry Ford, founded over 110 years ago.
In an op-ed piece in The Wall Street Journal (subscription required), Ford explains that the role of automakers is, necessarily, going to change to suit the needs of the future world. That means changing the view of not just the automobile, but the automaker. As Ford explains it, automakers will "move from being just car and truck manufacturers to become personal-mobility companies."