2003 Ford F-250 Super Duty Pickup Pa Inspection Green Nice Low Miles No Reserve on 2040-cars

Auto blog

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

Jaguar design boss admits X-Type was a mistake

History has a way of repeating itself, especially in the auto industry. When Jaguar was owned by Ford, the British brand attempted to field a competitor for the BMW 3 Series, called the X-Type. Based on the bones of a Ford Mondeo, it aped the styling of Jaguar's flagship model, the XJ, while borrowing liberally from the Ford parts bin. That was 2001.
Now, in 2013, Jaguar is planning a new 3 Series challenger based on the platform previewed by the C-X17 Concept, while Ford is attempting to take the latest Mondeo upmarket. The moves have both brands recognizing where, why, and how the X-Type failed. "It didn't look mature or powerful or anything. It was just a car," Jaguar's current head of advanced design, Julian Thomson, told PistonHeads. Basing the X-Type on a front-drive car while giving it styling that was meant for a rear-driver lead to proportions that "were plainly wrong," Thomson told PH. Ford's European head of quality, Gunnar Herrmann, added that the X-Type was "a fake Jaguar, because every piece I touch is Ford."
For what it's worth, the X-Type's successor in the segment will sport rear-drive, with plenty of input from Ian Callum. Thomson described the new model, which would challenge the 3 Series as having, "Big wheels right to the ends of the car, low bonnet, short overhangs, very low cabins." Sounds good to us.

Ford investing $2.5 billion in two new plants in Mexico

Automobile production keeps ramping up in Mexico. Last week alone, Toyota announced a new plant it's building south of the border, and news broke that Hyundai is looking into the same. Now Ford has announced a multi-billion-dollar initiative that will see it building two new facilities in Mexico, as well. Though neither will be a final assembly plant, both promise to break new ground for the automotive industry in Mexico – at least as far as Ford is concerned. The first is a new engine facility to be built at Ford's existing plant in Chihuahua. The fruit of a $1.1-billion investment will see the Blue Oval produce new gasoline engines for use in North America, South America and Asia-Pacific, creating 1,300 new jobs in the process. Ford will also be investing another $200 million to expand its inline-four and diesel engine production lines at the same plant. The move will create another 500 new jobs and make Ford's Chihuahua engine plant the largest in Mexico, according to the company's press release. Ford has also announced the building of its first transmission facility in Mexico, to be constructed within Getrag's plant in Irapuato in the state of Guanajuato. The $1.2-billion investment will create 2,000 new jobs and be charged with exporting two new automatic transmissions to markets around the world. The announcement comes on the 90th anniversary of Ford's presence in Mexico, dating back to 1925. Currently the company produces the Fiesta, Fusion and Lincoln MKZ in Mexico, as well as numerous Duratec and diesel engines. Related Video: FORD ANNOUNCES $2.5 BILLION USD INVESTMENT FOR NEW ENGINE, TRANSMISSION PLANTS IN MEXICO - Ford is investing $2.5 billion USD in new engine and transmission plants in the Mexican states of Chihuahua and Guanajuato, respectively - Approximately 3,800 direct jobs will be generated through three projects – a new engine plant in Chihuahua, expansion of Ford's I-4 and diesel engine lines in Chihuahua and a new transmission plant – Ford's first in Mexico – in Guanajuato - The investment is part of the company's One Ford plan, which emphasizes global competitiveness. The news comes as Ford celebrates its 90thyear in Mexico Further building its lineup of increasingly fuel-efficient engines and transmissions, Ford today announced a $2.5 billion investment in two new facilities building a new generation of engines and transmissions in the states of Chihuahua and Guanjuato, respectively.