2013 Ford F150 Xlt on 2040-cars

Auto blog

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

Ford recalling 390,000 cars over door latch woes

Ford is recalling certain Fiesta, Fusion and Lincoln MKZ vehicles due to faulty door latches, marking the latest in what seems to be a recurring issue for the Blue Oval. This is the third door latch recall from Ford in 2015, following a 213,000-unit recall in March and a 205,000-unit recall in January. This one, however, is significantly larger. A total of 390,000 units are affected, including Fusions and MKZs from model years 2013 and 2014, as well as Fiestas from model years 2012 to 2014. A "broken pawl spring tab" is the culprit, potentially keeping doors from latching shut. According to Ford, even if the door does shut, it could come open again without warning. The affected Fiestas were built between February 1, 2012 and May 31, 2013 at the Cuautitlan, Mexico factory. The Fusion and MKZ siblings, meanwhile, were screwed together at Hermosillo Assembly in Mexico between July 1, 2012 to May 31, 2013. Ford is aware of three minor reports of door malfunctions. In two cases, the door bounced back open, quite literally hitting drivers on their way out. In the third case, a door swung open of its own accord while a driver was attempting to park, hitting another vehicle. Ford will notify owners, who will need to report into dealers to have all four latches replaced. Scroll down for the official press release. Related Video: APR 24, 2015 | DEARBORN, MICH. FORD MOTOR COMPANY ISSUES SAFETY RECALL IN NORTH AMERICA FOR DOOR LATCH ISSUE ON FORD FIESTA AND FUSION, LINCOLN MKZ Ford Motor Company is issuing a safety recall for approximately 390,000 2012-2014 Ford Fiesta and 2013-2014 Ford Fusion and Lincoln MKZ vehicles for a door latch issue. The door latch in these vehicles may experience a broken pawl spring tab, which typically results in a condition where the door will not latch. If a customer is then able to latch the door, there is potential the door may unlatch while driving, increasing the risk of injury. Ford is aware of two allegations of soreness resulting from an unlatched door bouncing back when the customer attempted to close it, and one accident allegation when an unlatched door swung open and struck an adjacent vehicle as the driver was pulling into a parking space. Affected vehicles include certain 2012-2014 Ford Fiesta vehicles built at Cuautitlan Assembly Plant, Feb.

Ford shutters Genk assembly plant in Belgium

Ford has become the latest automaker to close one of its European assembly plants. The facility in question is located in the Belgian city of Genk and has been in operation since the early '60s when it started building the Taunus, Ford's first mass-produced, front-drive model. As part of the plan first announced over two years ago, the Genk Body & Assembly Plant is now closing its doors after half a century in the business and over fourteen million vehicles built. Although the plant itself employed some 5,000 workers, once you take into account the suppliers built up around the plant, the overall impact on employment in the area edges closer to 12,000. Genk Body & Assembly had until recently been tasked with producing the Mondeo sedan (which in its current iteration we know as the Fusion) as well as the S-Max and Galaxy minivans. Production of the Mondeo shifted in 2013 to the company's plant in Valencia, Spain, which also handles the Kuga crossover and Transit Connect cargo van, and will soon take over the minivans from Genk as well. The move follows a similar decision undertaken by General Motors to close the Opelwerk plant in Bochum, Germany. It also reflects a scaling down of automobile production in Belgium specifically: although Audi still manufacturers in Brussels and and Volvo in Ghent, Opel closed its plant in Antwerp in 2000 and Renault ceased production in Vilvoorde back in '97. However Ford still maintains its famous proving ground half an hour to the north in Lommel, Belgium. News Source: AutovisieImage Credit: Kristof Van Accom / AFP / Getty Plants/Manufacturing Ford plant ford s-max ford galaxy