1969 Ford F-100 95% Restored Selling Due To Health on 2040-cars

Auto blog

A cool boost to turbocharger performance

Since the advent of the forced-induction engine, we have been looking for ways to get every drop of performance we can. There are many approaches to getting additional power using better intercooling, water injection, or even adding nitrous oxide. One take on a short instant burst of power is being researched by Mahle and involves providing supercooled air to an engine, which allows it to burn a leaner fuel mixture and produce more power. The supercooling idea is not new and was examined by Ford in 1993 on the Mustang Mach III concept car, then brought up again in 2003 with the SVT F-150 Lightning concept. Ford called its system the SuperCooler; it was designed to work with any turbocharged or supercharged engine equipped with a water-to-air intercooler. The system on the Lightning concept used a small tank of antifreeze that was hooked up to the truck air conditioning compressor. The air conditioning compressor cooled the antifreeze down to about 30 degrees. The other side of the tank was hooked up to the air-to-water intercooler, which usually had a temperature over 100 degrees. Once the antifreeze was circulated from the tank into the intercooler, it would lower the intercooler temperature and provide for a cooler, denser air charge into the engine; the result was around 50 extra horsepower for a burst of about 30 seconds to a minute, depending on the size of the tank. The system for the Lightning was to be offered as a $750 option and would have been targeted towards drag racers and the like, as it could be used for a run down the drag strip and then re-cooled by the time the truck was back in line. The system was fairly non-intrusive – it only weighed about 25 pounds and did not require a new compressor or intercooler. But as with many concepts, it was ultimately scrapped. The technology was always stuck in the back of my mind, but with larger and more powerful engines being produced it could not find its place. With the advent of new fuel economy standards, we have seen small-displacement turbocharged engines pop up and they seem like the perfect candidate for this type of technology. Ford's EcoBoost 1.0-liter three-cylinder turbocharged engine, as used in the Fiesta and Focus, is one such candidate for this technology. It would add a negligent amount of weight but could provide a boost of 10 to 20 horsepower when needed, like merging onto the highway or catching up to traffic.

Ford exec reveals new F-150 Raptor packs 450 horsepower

Between the new GT supercar, Shelby GT350R muscle car and F-150 Raptor off-roader, Ford had quite the array of performance machinery on display at the Detroit Auto Show earlier this month. One thing it didn't reveal about any of the three, however, is how much power they'd pack, but a senior executive at the Blue Oval automaker has reportedly let the cat out of the bag when it comes to the Raptor. During a televised interview during the Rolex 24 at Daytona this past weekend, Ford's product development chief Raj Nair is said to have revealed that the new F-150 Raptor will offer 450 horsepower. That's pretty impressive from a 3.5-liter turbocharged V6, and would put the new Raptor out ahead of the 411 hp produced by the 6.2-liter naturally aspirated V8 in the previous SVT Raptor. That doesn't give us the whole picture, though, because in a vehicle this big especially, torque will play a huge factor. The outgoing Raptor offered 424 pound-feet of twist, and the existing 3.5-liter EcoBoost engine is already producing 420 lb-ft – so it seems fairly safe to assume the new Raptor will eclipse those figures as well, but we'll have to wait for official word to find out for sure. Related Video:

Ford recalling 390,000 cars over door latch woes

Ford is recalling certain Fiesta, Fusion and Lincoln MKZ vehicles due to faulty door latches, marking the latest in what seems to be a recurring issue for the Blue Oval. This is the third door latch recall from Ford in 2015, following a 213,000-unit recall in March and a 205,000-unit recall in January. This one, however, is significantly larger. A total of 390,000 units are affected, including Fusions and MKZs from model years 2013 and 2014, as well as Fiestas from model years 2012 to 2014. A "broken pawl spring tab" is the culprit, potentially keeping doors from latching shut. According to Ford, even if the door does shut, it could come open again without warning. The affected Fiestas were built between February 1, 2012 and May 31, 2013 at the Cuautitlan, Mexico factory. The Fusion and MKZ siblings, meanwhile, were screwed together at Hermosillo Assembly in Mexico between July 1, 2012 to May 31, 2013. Ford is aware of three minor reports of door malfunctions. In two cases, the door bounced back open, quite literally hitting drivers on their way out. In the third case, a door swung open of its own accord while a driver was attempting to park, hitting another vehicle. Ford will notify owners, who will need to report into dealers to have all four latches replaced. Scroll down for the official press release. Related Video: APR 24, 2015 | DEARBORN, MICH. FORD MOTOR COMPANY ISSUES SAFETY RECALL IN NORTH AMERICA FOR DOOR LATCH ISSUE ON FORD FIESTA AND FUSION, LINCOLN MKZ Ford Motor Company is issuing a safety recall for approximately 390,000 2012-2014 Ford Fiesta and 2013-2014 Ford Fusion and Lincoln MKZ vehicles for a door latch issue. The door latch in these vehicles may experience a broken pawl spring tab, which typically results in a condition where the door will not latch. If a customer is then able to latch the door, there is potential the door may unlatch while driving, increasing the risk of injury. Ford is aware of two allegations of soreness resulting from an unlatched door bouncing back when the customer attempted to close it, and one accident allegation when an unlatched door swung open and struck an adjacent vehicle as the driver was pulling into a parking space. Affected vehicles include certain 2012-2014 Ford Fiesta vehicles built at Cuautitlan Assembly Plant, Feb.