2014 Ford Explorer Xlt on 2040-cars

Auto blog

A cool boost to turbocharger performance

Since the advent of the forced-induction engine, we have been looking for ways to get every drop of performance we can. There are many approaches to getting additional power using better intercooling, water injection, or even adding nitrous oxide. One take on a short instant burst of power is being researched by Mahle and involves providing supercooled air to an engine, which allows it to burn a leaner fuel mixture and produce more power. The supercooling idea is not new and was examined by Ford in 1993 on the Mustang Mach III concept car, then brought up again in 2003 with the SVT F-150 Lightning concept. Ford called its system the SuperCooler; it was designed to work with any turbocharged or supercharged engine equipped with a water-to-air intercooler. The system on the Lightning concept used a small tank of antifreeze that was hooked up to the truck air conditioning compressor. The air conditioning compressor cooled the antifreeze down to about 30 degrees. The other side of the tank was hooked up to the air-to-water intercooler, which usually had a temperature over 100 degrees. Once the antifreeze was circulated from the tank into the intercooler, it would lower the intercooler temperature and provide for a cooler, denser air charge into the engine; the result was around 50 extra horsepower for a burst of about 30 seconds to a minute, depending on the size of the tank. The system for the Lightning was to be offered as a $750 option and would have been targeted towards drag racers and the like, as it could be used for a run down the drag strip and then re-cooled by the time the truck was back in line. The system was fairly non-intrusive – it only weighed about 25 pounds and did not require a new compressor or intercooler. But as with many concepts, it was ultimately scrapped. The technology was always stuck in the back of my mind, but with larger and more powerful engines being produced it could not find its place. With the advent of new fuel economy standards, we have seen small-displacement turbocharged engines pop up and they seem like the perfect candidate for this type of technology. Ford's EcoBoost 1.0-liter three-cylinder turbocharged engine, as used in the Fiesta and Focus, is one such candidate for this technology. It would add a negligent amount of weight but could provide a boost of 10 to 20 horsepower when needed, like merging onto the highway or catching up to traffic.

Next Ford Mustang to drop 400 pounds

The Ford Mustang is already the lightest of the current crop of muscle cars, at around 3,600 pounds for a GT coupe with the six-speed manual transmission. That's almost 260 pounds less than a Chevrolet Camaro SS and about 450 pounds less than a Dodge Challenger R/T, which means the Mustang has a pretty big advantage when it comes to handling, braking, accelerating and economy. More good news: The next Mustang will be even lighter.
According to a report from Edmunds, the sixth-generation Mustang, which is set to debut at the 2014 North American International Auto Show, will shed an additional 400 pounds of body fat. That 11-percent weight reduction will be thanks to lightweight materials, with a particular focus on using stronger, but less material in construction. Aluminum will feature heavily, but Edmunds' inside source warns that there is "nothing terribly exotic" coming to the original pony car.
The other big news is that the new Mustang will be smaller overall. It's going to be 15-inches shorter than the 188.5-inch Mustang on sale today, while it'll also be 6.5 inches narrower. Shorter overhangs, both in the front and rear, are also good signs for those that want an agile Mustang.

Vile Gossip | Adventures in tire testing

Jean Jennings has been writing about cars for more than 30 years, after stints as a taxicab driver and as a mechanic in the Chrysler Proving Grounds Impact Lab. She was a staff writer at Car and Driver magazine, the first executive editor and former president and editor-in-chief of Automobile Magazine , the founder of the blog Jean Knows Cars and former automotive correspondent for Good Morning America . She has lifetime awards from both the Motor Press Guild and the New England Motor Press Association. This is her first column for Autoblog — look for more Vile Gossip in the future. I began writing at Car and Driver magazine back in its golden age in the 1970s, before I'd actually read it. I knew very little about cars. The only magazine I read religiously was Four Wheeler because I owned big trucks and liked to go off-roading with my Chrysler Proving Grounds friends. My vast 10 years of driving experience up to that point (high-speed dirt-road idiot, taxicab driver, Chrysler Proving Grounds test driver) had less bearing on my being hired at Car and Driver than the fact that the editor just wanted to rile up the all-male staff. He didn't need me for that. They were already in full dudgeon when I arrived. They'd just spent a chunk of time testing a stack of tires for their big tire-test issue, and the editor-in-chief was toe-to-toe with the technical editor over the rankings of the top 10 tires. It was loud, and it was angry. I had no idea that car magazines tested tires. Cab driving had led me to believe that airing up a tire and changing a flat was all you needed to know. I changed so many flats on that cab, I eventually wound up in front of a live audience on the " Oprah Winfrey Show" demonstrating my brilliance with a jack and a tire iron. My point, of course, is that tires are more controversial, and also more essential, than you'd think. My other point is that it's good to get worked up about the subject, but not quite so good to let yourself be seen, as I did, on my hands and knees with my ass up in the air on national TV. This is how I prefer to test a tire: First, pick a top brand. Then accept their invitation to try and beat the crap out of their tire. I chose Yokohama, celebrating its 100th anniversary this year. The big news for them was the GEOLANDER M/T G003!