2004 Ford Expedition Eddie Bauer 39k Miles Navigation Extra Clean on 2040-cars

Auto blog

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

2014 Ford F-150 gets CNG option

Ford is toiling away, installing heavy-duty engine components into select 3.7-liter V6s to allow them to run on compressed natural gas (CNG) and liquid petroleum gas (LPG) in addition to gasoline. That's nothing new, but now, Ford has announced that it will offer the 2014 F-150 with this engine configuration, bringing the Blue Oval's total number of CNG/LPG-friendly vehicles up to eight. The F-150 will be the only half-ton pickup on the market that can run on these gases.
Ford will charge $315 per vehicle to equip the optional engine, but the trucks won't be ready to run on the alternative fuels straight from the factory and must be upfitted with additional equipment. A Ford Qualified Vehicle Modifier will install a separate fuel system for the compressed gases at a cost of $7,500 to $9,500, depending on fuel tank size. With the right-size tank, the F-150 equipped with the CNG/LPG-prepped engine can go 750 miles on one tank of gas, according to Ford, averaging 23 miles per gallon.
The practice of offering flex-fuel vehicles is gaining momentum as businesses take advantage of cheap gas. CNG can be bought for $2.11/gallon on average (per gasoline equivalent), and sometimes for as little as $1.00 in some parts of the US, Ford states. "With the money saved using CNG, customers could start to see payback on their investment in as little as 24 to 36 months," says Jon Coleman, Ford's fleet sustainability and technology manager. The automaker expects to sell a total of 15,000 CNG/LPG-prepped vehicles in the 2014 model year.

Creations n' Chrome Top Notch Mustang is a one-of-a-kind fox

Is there a cooler car from the 1980s and early 90s to mod than a Fox-body Ford Mustang? No, there isn't. If you disagree with us, we suggest you have a look at this 1990 Mustang Coupe, which just might change your mind. Although considering just how extensively modified this car - the Top Notch Mustang from Creations n' Chrome - is, we wonder just how much Ford is left in this old pony.
It rides on a custom race tube chassis that weighs a scant 700 pounds, while carbon-fiber bits and bobs help lower the overall curb weight to a mere 2,400 pounds. When paired with supercharged, 5.0-liter, Aluminator V8 from Ford Racing, the results are, doubtlessly, exciting. 855 horsepower at the rear wheels and 667 pound-feet of torque are available from that force-fed V8 should be just plenty for this car's intended purpose of running in standing-mile competitions.
The Top Notch Mustang is more extreme than just weight savings and a big engine, though. That 5.0-liter is essentially in what's known as a front-mid layout - where the engine is actually behind the front axle. In this case, the 5.0-liter V8 is 17 inches further back than a factory Fox-body, for better weight distribution. As a result, the cabin has been completely overhauled. An SLA front suspension, wheels from HRE, Wilwood brakes and Sparco interior items round out the extensive list of mods.